Craftsman 917273821 tractor dyt4000

User Manual - Page 32

For 917273821.

PDF File Manual, 56 pages, Download pdf file

Loading ...
Loading ...
Loading ...
TROUBLESHOOTmNG CHART:
See appropriate section in marluam unmess directed to Sears service center
PROBLEi_I CORRECTmON
Poor grass
discharge
i(continued)
iHeadiight(s) not
working
i(if so equipped)
iBattery wiii not
charge
Loss of drive
iEngine "backfires"
when turning
engine "OFF"
CAUSE
3. Wet grass.
4. Mower deck not level.
5. Low/uneven tire air pressure.
6. Worn, bent or loose blade.
7. Buildup of grass, leaves and
trash under mower.
8. Mower drive belt worn.
9. Blades improperly installed.
10. Improper blades used.
11.
Clogged mower deck vent
holes from buildup of grass,
leaves, and trash around
mandrels.
1. Switch is "OFF".
2. Bulb(s) or lamp(s) burned out.
3. Faulty light switch.
4. Loose or damaged wiring.
5. Blown fuse.
1. Bad battery cell(s).
2. Poor cable connections.
3. Faulty regulator
(if so equipped).
4. Faulty alternator.
1. Freewheel control in
"disengaged" position.
2. Motion drive belt worn,
damaged, or broken.
3. Air trapped in transmission
during shipment or servicing.
.
Engine throttle control not set
at "SLOW" position for 30
30 seconds before stopping
engine.
3. Allow grass to dry before
mowing.
4. Level mower deck.
5. Check tires for proper air
pressure.
6. Replace/sharpen blade.
Tighten blade bolt.
7. Clean underside of mower
housing.
8. Replace mower drive belt.
9. Reinstall blades sharp edge
down.
10. Replace with blades listed in
this manual.
11. Glean around mandrels to
open vent holes.
1. Turn switch "ON".
2. Replace bulb(s) or lamp(s).
3. ChecWreplace light switch.
4. Check wiring and connections.
5. Replace fuse.
1. Replace battery.
2. Check/clean all connections.
3. Replace regulator.
4. Replace alternator.
1. Place freewheel control in
"engaged" position.
2. Replace motion drive belt.
3. Purge transmission.
. Move throttle control to
"SLOW" position and allow
to idle for 30 seconds before
stopping engine.
32
Loading ...
Loading ...
Loading ...