1. Home
  2. Simpson Cleaning
  3. Simpson Cleaning SB65127 User Manual
  4. Page 17

Simpson Cleaning SB65127 Super Brute 49-State

User Manual - Page 17

For SB65127.

PDF File Manual, 28 pages, Read Online | Download pdf file

SB65127 photo
Loading ...
Loading ...
Loading ...
17
13.
Start engine/motor.
Gasoline or Diesel Driven: Refer to the engine instruction manual for
correct procedure. IMPORTANT: Prior to starting, refer to your engine
manual for proper startingprocedure.
WARNING: Gasoline or Diesel Driven only: Risk of unsafe operation. If engine
does not start after two pulls, squeeze trigger of gun to relieve pump pressure. Pull
starter cord slowly until resistance is felt. Then pull cord rapidly to avoid kickback
and prevent hand or arminjury.
NOTE: If the oil level in the engine is low, the engine will not start. If the engine does
not start, check the oil level and add oil asneeded.
Natural Gas/Propane Units:
Verify the control knob on the gas valve to the
ONposition.
14.
If hot water cleaning is desired
a.
Release the trigger on the gun and place the burner On/Off switch in the
ONposition.
b.
(if equipped) Turn the temperature control to the desired watertemperature.
WARNING: Risk of burns. The surfaces around the burner exhaust and the
discharged exhaust are very hot. Keep away from this area. DO NOT allow hoses
to come in contact with the very hot burner exhaustarea.
WARNING: Burner will shut off when the trigger is released. DO NOT use the
pressure washer if the burner fails to shut off when the trigger isreleased.
15.
Depress trigger on gun to start water flow and theburner.
WARNING: Risk of unsafe operation. Stand on a stable surface and grip gun/
wand firmly with both hands. Expect the gun to kickback whentriggered.
NOTICE: Allowing the unit to run for more than two minutes without the gun
trigger being pulled could cause overheating and damage to the pump. Do not let
the pressure washer run for more than two minutes in Bypass Mode. Turn off the
engine and relieve the pressure in the gun during these extendedsituations.
16.
Release trigger to stop water flow and turn the burneroff.
17.
Adjust the pressure if needed. Refer to
Pressure Adjustments
paragraph for the
correctprocedures.
DANGER: Risk of injury from spray. Engage the trigger lock
4
CC
(CC) when gun is not in use to prevent accidentalspraying.
SHUTTING DOWN (FIG. 1)
1.
Place the burner on/off switch in the OFFposition.
2.
Depress trigger on gun and allow water to run until the
spray wand is no longer hot to thetouch.
3.
If chemicals were applied, place the chemical siphon hose
into a container of clean water and draw clean water through chemical injection
system to rinse system thoroughly.
NOTICE: Risk of property damage. Failure to rinse the chemical system can cause
damage to the high-pressure pump or the high-pressure watersystem.
4.
Turn engine/motor off.
Gasoline or Diesel Driven: Refer to the engine instruction manual for
correctprocedure.
Loading ...
Loading ...
Loading ...