Loading ...
Loading ...
Loading ...
Malfunction
Possible cause
Remedy
The wine is too warm.
Heavy build up of frost,
possibly also on the
door seal.
Unusual noises.
The compressor does
not start immediately
after changing the
temperature setting .
Water on the floor.
Temperature is not properly
adjusted.
Door was open for an
extended period.
The appliance is near a heat
source.
Door seal is not air tight
(possibly after changing over
the hinges).
Appliance is not level.
The appliance is touching the
wall or other objects.
A component, e.g. a pipe,
on rear of the appliance is
touching another part of the
appliance or the wall.
This is normal, no error has
occurred.
Water drain hole is blocked.
Please look in the “Display
controls” section.
Open the door only as long as
necessary.
Please refer to the “Installing your
new appliance”section.
Carefully warm the leaking sections
of the door seal with a hair dryer (not
o
hotter than approx. 50 C) . At the
same time shape the warmed door
seal by hand such that it sits correctly.
Readjust the feet.
Move the appliance slightly.
If necessary, bend the component
out of the way carefully.
The compressor starts after a period
of time.
Please refer to the “Cleaning and
care” section.
Troubleshooting
If you experience a problem with your appliance or are concerned that the appliance
is not functioning correctly , you can carry out some easy checks before calling for
service, please see below.
Warning! Don’t try to repair the appliance yourself. If the problem persists after you
have made the checks mentioned below, contact a qualified electrician,authorized
service engineer or the shop where you purchased the product.
The setting temperature is
higher than the ambient
temperature
Set the temperature lower than the
ambient temperature as you want.
13
Loading ...
Loading ...