WTB2300WC USER MANUAL

Loading ...

Installation 5

Clean the refrigerator thoroughly according to instructions

and wipe away any dust that has accumulated during

shipping.

Check that the floor is level. If it is not, adjust the stabilising

foot so that the refrigerator is level and stable.

We recommend that the refrigerator be turned on and left

to run for two to three hours before placing any food inside

it. This will allow you to check that it is operating properly

and there is adequate cool air in the freezer.

INSTALLATION CLEARANCES

• Allowaminimumof30mmclearanceonbothsidesof

the refrigerator.

• Allowaminimumof50mmclearanceatthebackof

the refrigerator.

• Allowaminimumof10mmclearanceabovethe

hinge cover.

• Ifyoudonothaveacupboardwithareargap,the

recommended clearance at the back of the refrigerator

is 90mm.

• Whenpositionedinacorner,theclearancemustbe

at least 350mm on the hinge side to allow the door

to open smoothly so that bins and shelves can be

removed easily.

350mm

50mm

Recommended

airspace

CABINET

DOOR

30mm

90mm

NOTE: Refrigerator doors on all models are designed

to sit proud of cabinetry (not flush). The refrigerator should

be placed against a wall and the clearance between the

rear of the refrigerator and the wall should not be greater

than 75mm.

INITIAL START UP

When in operation, the outside of the refrigerator will feel

warm, particularly at start up. This is normal.

Avoid placing food against air outlets as this will impede

air circulation.

A light frosting will occasionally occur on the cold interior

of the freezer if the door is opened frequently. This is

normal and the frost will disappear after a few days in

most climates.

Makesurethatthefreezerandfreshfooddoorsarefully

closed after you have loaded or removed food from these

compartments. If the doors are left partly opened, a heavy

frost will coat the inside of the freezer. If this occurs, remove

thefrost.Ensurethatalldoorsareproperlyclosedtoprevent

INSTALLATION

frost from reappearing.

Your refrigerator uses energy efficient components that

may produce different noises from your old refrigerator.

Occasionally, a gurgling sound of refrigerant flowing or

sound of parts expanding or contracting can be heard.

These noises are quite normal.

CLEANING

Exterior

Clean the refrigerator with only lukewarm soapy water

and a soft cloth. Rinse the clean water and then wipe the

surface with a soft clean cloth to remove any soap residue.

Interior

Clean the refrigerator interior regularly. Turn power off.

Wipe the interior with a soft cloth and lukewarm soapy

water. Thoroughly dry all surfaces and removable parts.

Avoid getting water on the refrigerator controls. If you have

taken out any removable parts, replace them and switch on

the power before re-stocking the refrigerator. Wipe away

thoroughly any food spills.

Keep door seals clean

Ensurethatthedoorsealsarealwaysclean.Stickyfood

and drinks can cause seals to adhere to the cabinet and

may cause tear when opening the door. Wash seals with

lukewarm soapy water. Rinse thoroughly and dry.

WARNING

Never use hot water, solvents, commercial kitchen cleaners,

aerosol cleaners, metal polishers, caustic or abrasive

cleaners or scourers to clean the appliance as they will

damageit.Manycommerciallyavailablecleaningproducts

and detergents contain solvents that will damage your

refrigerator. When cleaning, use only a soft cloth and

lukewarm soapy water.

Loading ...

USER MANUAL - Page 5