Loading ...
Loading ...
Loading ...
page 8
10. Testing Your Fan.
It is recommended that you test fan before
finalizing installation. Restore power from circuit
box and light switch (if applicable). Test fan speeds
with pull chain located on switch housing. Start at
the OFF position (no blade movement). First pull
will set the fan to HI. Second pull will set the fan to
MEDIUM. Third pull will set the fan to LOW. Fourth
pull will again set the fan to the OFF setting. Test
light with the pull chain in the middle. (diagram 1)
If fan does not function, please refer to
"Troubleshooting" section to solve any issues
before contacting Customer Service.
Turn fan completely off before moving the reverse
switch. Set reverse switch to recirculate air
depending on the season:
- LEFT position in summer (diagram 2)
- RIGHT position in winter (diagram 3)
A ceiling fan will allow you to raise your thermostat
setting in summer and lower your thermostat
setting in winter without feeling a difference in
your comfort.
Important: Reverse switch must be set either
completely LEFT or completely RIGHT for fan to
function. If the reverse switch is set in the middle
position (diagram 4), fan will not operate.
Attach pull chain extension(s) supplied or custom
pull chain extension (sold separately) to the end(s)
of the pull chain(s).
reverse
switch
diagram 1
pull chain
extensions
9. Light Kit Assembly (Optional). (cont).
Locate cap in one of the hardware packs and
place cap firmly into hole in middle of switch
housing.
Align holes in switch housing with holes in fitter
plate. Secure switch housing with the 3 screws
previously removed. Tighten all 3 screws
securely. [Refer to diagram 4.]
switch
housing
cap
diagram 4
diagram 2
diagram 3
diagram 4
Loading ...
Loading ...
Loading ...