Loading ...
Loading ...
Loading ...
page 6
8. Blade Assembly.
motor housing
7. Canopy Assembly.
canopy
hanging bracket
magnet
Insert the end of one blade arm into the keyhole
slot on the motor housing. Twist blade arm
clockwise until it clicks to lock in place.
Repeat with remaining blade arms.
J
keyhole
slot
blade arm
WARNING: To reduce the risk of serious bodily
injury, DO NOT use power tools to assemble the
blades. If overtightened, blades may crack and
break.
Locate 15 three-C clips in hardware pack. Align the
blade screw posts on blade arms with the holes on
a blade.
Press on the blade arm firmly so the blade screw
posts come through the holes in the blade, then
slide a three-C clip onto each blade screw post.
Repeat for each blade arm and blade.
WARNING: To reduce the risk of personal injury,
make sure the friction detents on three-C clip face
down and recessed groove faces up. Slide three-C
clips completely under blade screw posts so edges
of blade screw posts are captured by the recessed
groove on the three-C clips.
friction
detents
recessed
groove
X
blade
screw
post
three-C clip
blade
blade arm
Raise canopy toward ceiling and allow it to attach
to hanging bracket using the magnets mounted on
each side of the hanging bracket. Carefully peel
away the plastic wrapping around the downrod
sheath.
Note: Should you need to lower the canopy for any
reason, use care in lowering the canopy over the
downrod sheath to prevent scratching the metal
surfaces.
Loading ...
Loading ...
Loading ...