Loading ...
Loading ...
Loading ...
iiiiiiiiiiiiiiiiiiiiii_!i:ii:i_:_!_S!_iii_i_i_i_i!_i!!_!ii_ii_i_i_i_!_!i!ii_i_ii_ii_ii_ii_ii_ii_ii_ii_ii_ii_ii_ii_ii_ii!ii_iiii_i_!i!_!_i_!_!_ii
Solutions to Common Problems
DISHWASHER WON'T FiLL ERROR CODES
:::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::
• Check to see if the water supply is turned on. '..................................................................
In certain situations which are critical to the
• Add 1/2 cup of water to the bottom of the unit
machines function and safe operations.
and start again.
DISHWASHER HAS AN ODOR
• Soiled dishes left in dishwasher too long can
create an odor. Use Rinse cycle.
• There will be a "new" smell when first
installed. This is normal.
Check to see if unit is draining properly (See
Dishwasher Does Not Drain Properly, page
20).
REMOWNG SPOTS AND
Hard water can cause lime deposit build-up on the
interior of the dishwasher. Dishes and glasses may
also get spots and film for a number of reasons
(See Glassware/Flatware Spotted or Cloudy, page
19).
To remove build-up, spots and film, clean
using the following instructions:
1 Load clean dishes and glasses in normal
manner. Do not load any metal utensils or
silverware.
2 Do not add detergent.
3 Selectthe NORMALWASH cycle. Press
START/CANCEL pad and close door.
4 Allow dishwasher to run until it begins the
second fill. Open door and pour 2 cups of
white vinegar into the bottom of dishwasher.
5 Close and latch door and allow cycle to
finish.
Error 01
Leak Detector - When water is detected under
the tub.
Error 02
Thermistor - When thermistor/turbidity module
fails
Error 03
Wash Pump - Wash pump not operating
Error 04
Drying Damper - Drying damper not operating
Error 05
Upper Fan - When in the dry cycle, the control
board does not receive proper speed feedback
from the upper fan
Error 06
Lower Fan - When in the dry cycle, the control
iiiiiiiiiiiiiiii
board does not receive proper speed feedback
from the lower fan
Error 07
Drain Valve - When in the drain mode, the control
board does not receive proper position feedback
from the drain valve
Error 08
Tactile or touch switch - Control board has
verified a switch on the user interface is bad or
shorted
Error 09
Communications - Communication failure be-
tween main user board and power supply
Error 10
Mains Relay - Failure in the mains power relay
Error 11
Drain Valve - Time out before finding a state for
the drain valve
Error 12
Drain Valve - The drain valve is running when it
should be off
Error 13
System wide - Lost control of the State Machine
Loading ...
Loading ...
Loading ...