American Outdoor Grill 3282L L Series Builtin Double Side Bu

User Manual - Page 4

For 3282L.

PDF File Manual, 16 pages, Read Online | Download pdf file

Loading ...
Loading ...
Loading ...
4
REV 2 - 1401030955
L-C2-356
PREPARING FOR INSTALLATION
Your double sideburner is designed to complement
your grill. It provides a convenient, efficient
cooking surface for side dishes that require
bottom heat only.
TOOLS REQUIRED
The double sideburner has been pre-assembled.
You need only a pair of wrenches, pliers, or vice
grips for the gas connection.
CODE AND SUPPLY REQUIREMENTS
This burner must be installed in accordance with
local codes and ordinances, or, in the absence
of local codes, with the National Fuel Gas Code,
ANSI Z223.1.
This appliance and its individual shutoff valve
must be disconnected from the gas supply piping
system when testing the system at pressures in
excess of
1
/
2
psig (3.5 kpa).
The appliance must be isolated from the gas supply
piping system by closing its individual manual shutoff
valve during any pressure testing of the gas supply
system at pressures up to and including
1
/
2
psig
(3.5 kpa).
Do not install this unit under unprotected
ammable surfaces. Do not install or use this
appliance inside a building, garage, or any
other covered area. It must not be used in or
on recreational vehicles or boats.
This is a built-in type unit designed to fi t into open-
front enclosures. The control panel of the unit is
removable for gas hookup, servicing, and burner
adjustment. The control panel must be removable
after you install the unit.
INSTALLER NOTE: This unit should be installed
so that it can be removed at a later date if factory
service is required. Any protrusion into the double
sideburner enclosure may prevent the unit from
sliding into place (see GAS SUPPLY PLUMBING
REQUIREMENTS, on page 5).
ENSURING PROPER COMBUSTION AIR AND
COOLING AIR FLOW
You must maintain proper air fl ow for your double
sideburner to perform as it was designed. If airfl ow
is blocked, overheating and poor combustion will
result. Make sure not to block the 1" front air inlet
along the bottom of the control panel or more than
75% of the support grid surface with pans or griddles.
WHERE TO INSTALL YOUR
DOUBLE SIDEBURNER
FOR OUTDOOR USE ONLY.
ELECTRICAL OUTLETS
Electrical outlets in the vicinity of this appliance
must be properly grounded and GFCI equipped.
Important: This unit may be installed into
combustible framing (wood, for instance)
provided there is a minimum of a
1
/
2
"
airspace between the sides of the unit
and any combustible material. The unit
is equipped with tabs on the sides and
rear panels to assist in maintaining
this
1
/
2
" airspace. Use pliers to bend
them outward as needed. This hanger
requires 1
1
/
2
" of countertop on each
side and back to support the unit.
Sideburner
Sideburner
Countertop
Counter Counter
Maintain air gap all the
way down (back and
side) under countertop
Edge of
counter
cut-out
2
1
/
4
"
Hanger
2
1
/
4
"
Min.
1
/
2
"
Max.
3
/
4
"
air gap to all
combustible
material*
Fig. 4-1 Top View
Fig. 4-2 Front View
Stainless
steel
hanger
Hanger
*
Use tabs on side and rear of unit
to assist in this clearance.
Loading ...
Loading ...
Loading ...