Loading ...
Loading ...
Loading ...
STARTING INSTRUCTIONS
WARNING: AvoidaccidentaH
starting. Make sure
you are in the starting position when using
the snow thrower. To avoid serious injury,
the operator and unit must be in a staMe
position while starting.
You must follow this sequence correctHy to start the unit.
1. Make sure you have pHugged in the unit.
2. Press in and hoHdthe red starter button (Fig. 4).
3. WhiHehoHding the starter button, lift and hoHdthe bail
NOTE: The unit will NOT start if you faiHto press and
hoHdthe starter button untiHyou Hiltthe bail
4. HoHdthe bail and begin operating the unit (Fig. 5).
STOPPING iNSTRUCTiONS
1. Release your hand from the bail.
2. The starter button will pop out and the unit will stop.
Overload
Protection
Switch
F_g. 4
OVERLOAD PROTECTION SWITCH
This unit is equipped with an ovedoad protection switch
to protect the circuit (that the unit is plugged into) from
short circuit overloads.
If the switch pops out:
1. Release the bail and allow the unit to stop and cool
for a minute.
2. Press the overload switch to reset. Resume
operation (Fig. 4).
If the switch pops again shortly after the first time:
1. Allow the unit to cool for 15 to 30 minutes.
2. After the unit has cooHed, press the ovedoad switch
to reset. Resume operation.
If the switch does not stay in, or if it continues to pop out
during operation, take the unit to an authorized service
dealer for repair.
OPERATmNG THE UNmT
1. Start the unit according to the Starting Instructions.
The depth and weight of the snow governs the
forward speed.
2. Push the unit so that it rides on the wheels and
scraper.
3. Make sure the power cord is attached to the cord
retainer and rests on the guide bar. The power cord
should trail to the side of the operator.
Loading ...
Loading ...
Loading ...