GE - General Electric DPGT750EC2WW GE electric dryer

User Manual - Page 18

For DPGT750EC2WW.

PDF File Manual, 44 pages, Download pdf file

Loading ...
Loading ...
Loading ...
Installation
Instructions
Dryer
DPGT750
I Questions? Call 800.GE.CARES (800.432.2737) or visit our Web site at: ge.com
BEFORE YOU BEGIN
Read these instructions completely and
carefully.
IMPORTANT - Savethese
instructions for local electrical inspector's
use.
IMPORTANT - Observeallgoverning
codes and ordinances,
Note to Installer - Be sure to leave these
instructions with the Consumer.
Note to Consumer - Keep these instructions
for future reference.
This dryer must be exhausted to the
outdoors.
Before the old dryer is removed from service
or discarded, remove the dryer door.
Service information and the wiring diagram
are located in the control console.
Do not allow children on or in the appliance.
Close supervision of children is necessary
when the appliance is used near children.
Proper installation is the responsibility of
the installer.
Product failure due to improper installation
is not covered under the Warranty.
Gas dryers are not approved for mobile
home installation.
FOR YOUR SAFETY:
WARNING
Use only rigid metal or flexible metal 4-inch
diameter ductwork for exhausting to the
outdoors. Never use plastic or other
combustible easy-to-puncture ductwork.
This appliance must be properly
grounded and installed as described in
these instructions.
Do not install or store appliance in an area
where it will be exposed to water and/or
weather.
The National Fuel Gas Code restricts
installations of gas appliances in garages.
They must be 18 inches off the ground and
protected by a barrier from vehicles,
Install the dryer where the temperature is
above 50°F for satisfactory operation of the
dryer control system.
FOR GAS MODELS ONLY:
NOTE: Installation and service of this dryer
must be performed by a qualified installer,
service agency or the gas supplier.
In the Commonwealth of Massachusetts:
This product must be installed by
a licensed plumber or gas fitter.
When using ball-type gas shut-off valves,
they shall be T-handle-type.
A flexible gas connector, when used,
must not exceed 3 feet.
I
18
Loading ...
Loading ...
Loading ...