Loading ...
Loading ...
Loading ...
10. MAINTENANCE
- 15 -
Air intake
Filter
Fan Guard
Upper Shell
Air Output Filter
Intake
Filter
End Filter
Cover
Lint Filter
Warning: Never service heater while it is plugged in or while
hot!
USE ORIGINAL EQUIPMENT REPLACEMENT PARTS. Use
of third-party or other alternate components will void warranty
and may cause unsafe operating conditions.
10.1 FUEL TANK
Flush every 200 hours of operation or as needed.
10.2 AIR INTAKE FILTER
WASH AND DRY WITH SOAP AND WATER EVERY 500
HOURS OF OPERATION, OR AS NEEDED.
- Remove screws along side of heater using No.2 cross slot
screwdriver.
- Lift off upper shell.
- Remove fan guard.
- Wash or replace air intake filter.
- Reinstall fan guard and upper shell
10.3 AIR OUTPUT FILTER, LINT FILTER
REPLACE EVERY 500 HOURS OF OPERATION OR ONCE A
YEAR
- Remove upper shell and fan guard.
- Remove end filter cover screws using No.2 cross slot
screwdriver.
- Remove end filter cover
- Replace air output and lint filter
- Reinstall end filter cover.
- Reinstall fan guard and upper shell
10.4 FAN BLADES
CLEAN EVERY SEASON OR AS NEEDED
- Remove upper shell (See Air Intake Filter).
- Use M6 hex. key to loosen set screw which holds fan
blade to motor shaft.
- Slip fan blade off motor shaft.
- Clean fan blade using soft cloth moistened with water and
a mild detergent.
- Dry fan blade thoroughly.
- Reinstall fan blade to motor shaft.
- Place fan blade hub flush with end of motor shaft.
- Place set screw on flat of shaft.
Loading ...
Loading ...
Loading ...