Loading ...
Loading ...
Loading ...
page 7
7. Canopy Assembly.
8. Blade Assembly.
Locate 2 screws on underside of hanging bracket
and remove screw closest to the open end of the
hanging bracket. Partially loosen the other screw.
Lift canopy to hanging bracket. Place rounded part
of slotted hole in canopy over loosened screw in
hanging bracket and push up. Twist canopy to lock.
Re-insert screw that was removed, and then tighten
both screws securely. Slide canopy cover up to
canopy, aligning rounded part of slotted holes in
canopy cover with screw heads in bottom of
canopy. Turn cover to the right (clockwise) until it
stops.
hanging bracket
screw
screw
canopy cover
Time Saver: Washers for blade screws can be set on
each blade screw prior to installing blades.
Locate 24 blade attachment screws and washers in
hardware pack. Slide blade through one of the
narrow, rectangular openings on motor housing,
aligning holes in blade with holes in blade arm
(located on the underside of the motor
housing)--refer to drawing at right. [Be sure to note
label on blade indicating THIS SIDE UP.] Then, place
blade plate over holes in blade arm, making sure to
align all 4 holes, as shown in drawing at right.
Partially insert 4 blade attachment screws (along
with washers). Securely tighten screws with Phillips
screwdriver only after all 4 screws have been
inserted. Repeat procedure for remaining blades.
Note: Tighten blade arm screws twice a year.
blade
motor housing
9. Switch Housing Assembly.
Remove 3 screws from outer edge of switch
housing plate (save screws for later use).
Remove 1 screw from fitter plate on underside
of motor and partially loosen the other 2 screws.
Align slotted holes in center of switch housing
plate with loosened screws in fitter plate,
allowing molex plugs from motor housing to
come through hole in middle of switch housing
plate. Twist switch housing plate to lock.
Re-insert screw that was removed and secure all
screws.
Align holes in switch housing cap with holes in
switch housing plate. Re-insert screws that were
previously removed and use a Phillips
screwdriver to secure all screws.
switch housing
plate
switch
housing cap
molex
plugs
fitter
plate
motor housing
canopy
blade attachment
screws and washers
blade arm
blade plate
Loading ...
Loading ...
Loading ...