Loading ...
Loading ...
Loading ...
2. Move the motion control lever 1/4 to
1/2 inchin the directionit is trying to
creep.
3. Tighten adjustment bolt securely.
4. Start engine and test.
5. If tractor stillcreeps, repeat above
steps untilsatisfied.
MotionControl NsulralLockGate
Lever
TRANSMISSION REMOVAUREPLACE-
MENT
Should your transmission require
removal for service or replacement, it
should be purged after reinstallationand
before operating the tractor. See
"PURGE TRANSMISSION" inthe
Operation section of this manual.
TO ADJUST STEERING WHEEL ALIGN-
MENT
If steedng wheel crossbars are not
horizontal (leftto dght) when wheels are
positionedstraight forward, remove
steedng wheel and reassemble per
instructionsin the Assembly section of
this manual.
FRONT WHEEL TOE-IN/CAMBER
The front wheel toe-in and camber are
not adjustable on your tractor. If damage
has occurred to affect the front wheel toe.
in or camber, contact a Sears or other
qualified service center.
TO REMOVE WHEEL FOR REPAIRS
1. Blockup axle securely.
2. Remove axle cover, retaining dng and
washers to allow wheel removal (rear
wheel contains a square key - Do not
lose).
3. Repair tire and reassemble.
NOTE: On rear wheels only: align
grooves in rear wheel hub and axle.
Insert square key.
4. Replace washers and snap retaining
dng securely in axle groove.
5. Replace axle cover.
NOTE: To seal tire puncturesand prevent
flat tires due to slow leaks, tire sealant
may be purchased from your local parts
dealer. Tire sealant also prevents tire dry
rot and corrosion.
(RearWheelOnly)
TO START ENGINE WITH A WEAK
BA'i-I'ERY
A
4BkCAUTION: Lead-acidbatteriesgenerate
explosivegases. Keapsperks,itarn_ and
srno_ng materialsawayfrom batteries.
Alwayswear eye protectionwhen around
batteries.
it yourbatteryistooweaktostartthe engine, it
shoLldbe recharged.(See "BATTERY"inthe
MAINTENANCE section of this manual).
If"jumper cables"are used for emergency
starting,follow this procedure:
IMPORTANT: Yourtractor is equippedwith a
12 voltnegative grounded system.The other
vehical must also be a 12volt negative
grounded system. Do not use your tractor
batteryto startothervehicles.
TO A'I-rACHJUMPER CABLES-
1. Connect each end of the RED cable to
the POSITIVE (+) terminal ofeach
battery, taking care not to short
against chassis.
2. Connect one end of the BLACK cable
to the NEGATIVE (-) terminal of fully
charged battery.
3. Connect the other end of the BLACK
cable to good CHASSIS GROUND,
away from fuel tank and battery.
TO REMOVE CABLES,REVERSE ORDER -
1. BLACK cable first from chassis and
then from the fully charged battery.
2. RED cable last from both batteries.
PositiveTerminal
= Cables
Positive Battery
26 Terminal
Loading ...
Loading ...
Loading ...