Loading ...
Loading ...
Loading ...
The operation of any tractor can result in foreign objects thrown intothe
eyes, which can resultin severe eye damage. Always wear safety
glasses or eye shields while operating your tractor or performing any
adjustments or repairs, We recommend a wide vision safety mask over
spectacles or standard safety glasses.
HOWTO USEYOURTRACTOR
TO SET PARKING BRAKE
Your tractoris equipped with an operator
presence sensing switch. When engine
is running,any attempt by the operator to
leave the seat without first settingthe
parking brake will shut off the engine.
1. Depress clutch/brake pedal into full
"BRAKE" positionand hold.
2. Place parking brake lever in =EN-
GAGED" positionand release
pressure from clutch/brake pedal.
Pedal should remain in "BRAKE"
position, Make sure parking brake will
hold tractorsecure,
Throttle] AttachmentClUtchLever
Choke "Engaged"
Control\ . position
• IgnitionKey
=Disengaged"
Clutch/ Brake
Brake Pedal
Position
Lever
Position
STOPPING
MOWER BLADES -
• To stop mower blades,move attach-
ment clutch lever to "DISENGAGED"
position.
GROUND DRIVE -
• To stop ground drive, depress clutcW
brake pedal into full "BRAKE" position.
• Move motion control lever to neutral (N)
position.
IMPORTANT: The motion control lever
does not return to neutral (N) position
when the clutch/brake pedal is de-
pressed.
ENGINE -
• Move throttle controlto slow position.
NOTE: Failure to move throttle control to
slow position and allowing engine to idle
before stopping may cause engine to
"backfire".
• Turn ignkion key to =OFF" position and
remove key. Always remove key when
leaving tractor to prevent unauthodzed
use.
13
• Never use choke to stop engine.
IMPORTANT: Leaving the ignition switch
in any position other than "OFF" will
cause the battery to be discharged,
(dead).
NOTE: Under certain conditions when
tractor is standing idle with the engine
running,hot engine exhaust gases may
cause "browning" of grass.To eliminate
this possibility,always stop engine when
stoppingtractor on grass areas.
ACAUTION: Alwaysstop tractorcom-
pletely,as describai:tabove, before
leavingthe operator's position;to empty
grass catcher, etc.
TO USE THRO'I-FLE CONTROL
Always operate engine at full throttle.
• Operating engine at lessthan full
throttle reduces the battery charging
rate.
• Full throttleoffers the best bagging and
mower performance.
TO MOVE FORWARD AND
BACKWARD
The direction and speed of movement is
controlled by the motion control lever.
1. Start tractor with motion control lever
in neutral (N) position.
2. Release parking brake.
3. Slowly move motion control lever to
desired position.
TO ADJUST MOWER CUI"FING HEIGHT
The positionof the attachment lift lever
determines the cutting height.
• Grasp liftlever.
• Press plunger with thumb and move
lever to desired position.
The cutting height range is approxi-
mately 1-1/2 to 4". The heightsare
measured from the ground to the blade
tip with the engine not running. These
heights are approximate and may vary
depending upon soil conditions, height of
grass and types of grass being mowed.
• The average lawn should be cut to
approximately 2-1/2 inches dudng the
cool season and to over 3 inches
dudng hot months. For healthier and
better looking lawns, mow often and
after moderate growth.
Loading ...
Loading ...
Loading ...