Loading ...
Loading ...
Loading ...
6
Grounding your Appliance
A 115 Volt (AC only) 60 Hz grounded electrical supply with a 15- or 20- amp fuse or circuit breaker is
required. It is recommended that a separate circuit serving only your appliance be provided. Use
outlets that cannot be turned off by a switch or pull chain. Do not use an extension cord.
Key Eject Lock
Some models have factory-installed lock to secure the contents of the unit. To lock or unlock the
appliance, you must hold the key in the lock while turning. The lock is spring loaded, so the key
cannot be left in the lock.
If the key is lost, contact your dealer or SUMMIT APPLIANCE for a replacement. Always give the
model and serial number of your appliance when requesting a replacement key. Keys for most
models can be ordered online at www.summitappliance.com/support
Reversing the Door Swing
For select units, if you find the direction of opening the door on your appliance inconvenient, you can
change it. Holes on the opposite side have already been prepared in the factory.
For Select One-Door Units
• Take off the upper hinge cover from the door and
remove the screws that hold the top hinge.
• Lift the hinge straight up to free the hinge pin from
the socket in the top of the door.
• Lift the door up and away to free its bottom
socket from the hinge pin.
• Remove the screws to the bottom hinge.
• Remove the decorative caps from the opposite side and plug the holes from the original side with
the decorative caps.
• Move the bottom hinge to the opposite side and tighten the screws. Install
any lock washers or nuts if they were used in the original installation.
• Replace door onto the hinge pin on the bottom hinge. Place top hinge pin
into door. Insert screws into the top hinge and tighten.
Loading ...
Loading ...
Loading ...