Kenmore 10654206300 refrigerator

User Manual - Page 13

For 10654206300.

PDF File Manual, 80 pages, Download pdf file

Loading ...
Loading ...
Loading ...
The Dispenser Lock
Your dispenser can be turned off for easy cleaning or to prevent
accidental dispensing by small children and pets. To turn off the
dispenser, press and hold the lock button until the red indicator
appears below LOCKED. The ice and water dispensers will not
work. To unlock the dispenser, press the lock button until the
indicator disappears. Then continue to dispense ice or water as
usual.
LOCKED
NOTE: The lock feature does not shut off power to the product,
to the ice maker, or to the dispenser light. It simply deactivates
the dispenser levers.
The water filter status display will help you know when it is time
to change your water filter cartridge. A new water filter cartridge
should display a reading of 99%. The number on the display
decreases as the filter life is used. To change the water filter
cartridge, see "Changing the Water Filter Cartridge" later in this
section.
INDICATOR STATUS
99 percent New filter installed
10 percent Order replacement filter
0 percent OR flow decreases Replace filter
After replacing the base grille water filter cartridge, reset the
water filter status display by pressing and holding RESET for 2
seconds. The display will change to 99% when the filter indicator
is reset.
WATERFILTER
PERCENTREMAINING
2. Remove the cartridge cap by sliding it off the end of the old
cartridge. The cap will slide to the left or right. DO NOT
DISCARD THE CAR
3. Take the new cartridge out of its packaging and remove
protective cover from o-rings.
4. Slide the cartridge cap onto the new cartridge. See
illustration in Step 2.
5. With cartridge cap in the vertical position, push the new filter
cartridge into the base grille until it stops. Rotate the cartridge
cap clockwise to a horizontal position. Flush the water
system (see "Flushing the Water System After Replacing
Filter" section).
Flushing the Water System After Replacing Filter _
Use a sturdy container to depress the water dispenser bar until
the water begins to flow. Flush the water system by dispensing _d3_
and discarding 2 to 3 gal. (8 to 12 L) of water. Cleaning the
system will take approximately 6 to 7 minutes and will help clear
air from the line. Additional flushing may be required in some
households.
NOTE: As air is cleared from the system, water may spurt out of
the dispenser.
Using the Dispenser Without the Water Filter
You can run the dispenser without a water filter cartridge. Your
water will not be filtered.
1. Remove the base grille water filter cartridge.
2. Slide the cartridge cap off the end of the filter cartridge. DO
NOT DISCARD THE CAR With the cartridge cap in the
vertical position, insert the cap into the base grille until it
stops.
NOTE: Do not use with water that is microbiologicany unsafe
or of unknown quality without adequate disinfection before
or after the system. Systems certified for cyst reduction may
be used on disinfected waters that may contain filterable
cysts.
Changing the Water Filter Cartridge
f.
Locate the water filter cartridge cap in the front base grille.
Rotate the cap counterclockwise to a vertical position and
pull the cap and filter cartridge out through the base grille.
NOTE: There will be water in the cartridge. Some spilling may
OCCUR
3. Rotate the cartridge cap to a horizontal position. The
cartridge cap might not be even with the base grille.
13
Loading ...
Loading ...
Loading ...