Loading ...
Loading ...
Loading ...
The Ice Dispenser The Water Dispenser
Ice dispenses from the ice maker storage bin in the freezer. When
the dispenser lever is pressed:
• A trap door opens in a chute between the dispenser and the
ice bin. Ice moves from the bin and falls through the chute.
• When you release the dispenser lever, the trap door closes
and the ice dispensing stops. The dispensing system will not
operate when the freezer door is open.
If you did not flush the water system when the refrigerator was
first installed, press the water dispenser bar with a glass or jar
until you draw and discard 2 to 3 gal. (8 to 12 L) or approximately
6 to 7 minutes of water after water begins dispensing. It will take
3 to 4 minutes for the water to begin dispensing. The water you
draw and discard cleans the system and helps clear air from the
lines. Allow several hours for the refrigerator to cool down and
chill water.
Before dispensing ice, select which type of ice you prefer. The
button controls are designed for easy use and cleaning.
• For cubed ice, press the ice cube button until the green
indicator appears in the window below CUBED.
• For crushed ice, press the ice cube button until the green
indicator appears in the window below CRUSHED.
CRUSHED CUBED
For crushed ice, cubes are crushed before they are dispensed.
This may cause a slight delay when dispensing crushed ice.
Noise from the ice crusher is normal, and pieces of ice may vary
in size. When changing from CRUSHED to CUBED, a few ounces
of crushed ice will be dispensed along with the first cubes.
To dispense ice:
1. Press button for the desired type of ice.
2. Press a sturdy glass against the ice dispenser lever. Hold the
glass close to the dispenser opening so ice does not fall
outside of the glass.
IMPORTANT: You do not need to apply a lot of pressure to
the lever in order to activate the ice dispenser. Pressing hard
will not make the ice dispense faster or in greater quantities.
IMPORTANT: The small removable tray at the bottom of the
dispenser is designed to catch small spills and allow for easy
cleaning. There is no drain in the tray. The tray can be removed
from the dispenser and carried to the sink to be emptied or
cleaned.
To dispense water:
1. Press a glass against the water dispenser lever.
2. Remove the glass to stop dispensing.
NOTE: Water may have an off-flavor if you do not use the
dispenser periodically. Dispense enough water every week to
maintain a fresh supply.
The Dispenser Ught
When you use the dispenser, the lever will automatically turn the
light on. If you want the light to be on continuously, you may
choose either ON or AUTO.
ON AUTO
3. Remove the glass to stop dispensing.
NOTE: The first few batches of ice may have an off-flavor
from new plumbing and par_s. Throw the ice away. Also, take
large amounts of ice from the ice bin, not through the
dispenser.
ON: Press the light bulb button at the right-hand side of the
dispenser control panel to turn the dispenser light on. The green
indicator will appear below ON.
AUTO: Press the light bulb button a second time to select the
Auto mode. The green indicator will appear below AUTO. The
dispenser light will automatically adjust to become brighter as the
room brightens, dimmer as the room darkens.
OFF: Press the light bulb button a third time to turn the dispenser
light off.
The dispenser lights are LEDs which should not need to be
changed. If it appears that your dispenser lights are not working,
check to be sure that the light sensor is not blocked (in Auto
mode). See "Troubleshooting" for more information.
12
Loading ...
Loading ...
Loading ...