Loading ...
Loading ...
Loading ...
A fault, what to do?
11
TR2000 | TR2000R – 6 720 876 014 (2017/08)
8 A fault, what to do?
WARNING:
Attention!
Repairs must only be carried out by an authorised technician. Improper
repairs can lead to risk of serious injury to the user.
If your appliance does not operate as required, it is often due to a very
minor problem. Please check whether you can remedy the fault yourself
by using the following guidelines. You will save yourself the costs of an
unnecessary visit by customer service personnel.
If the fault could not be eliminated, please call customer service.
9 Disposal 10 Guarantee
The guarantee conditions for this appliance are as defined by our
representative in the country in which it is sold.
Details regarding these conditions can be obtained from the dealer from
whom the appliance was purchased. The bill of sale or receipt must be
produced when making any claim under the terms of this guarantee.
Subject to change without notice.
Fault Cause Solution Who
Water flow-rate is too low.
The appliance does not switch on.
The filter in either the water tap or
the showerhead is clogged.
Remove the filter and either clean it or
descale it.
Customer
The filter in the corner valve is clogged. Get a servicing expert to clean the filter. Servicing expert
The corner valve is clogged. Turn on the hot-water tap fully and open
and close the corner valve several times.
Then clean the filter in the water tap.
Customer
The water is not sufficiently warm. The fuse in the house electrical
installation has tripped/blown.
Check the fuse in the fusebox. Customer
The appliance‘s automatic circuit breaker
has been tripped.
Get the appliance‘s automatic circuit
breaker checked by an electrician. Check
the permissible supply temperature.
Servicing expert
The power limit has been reached. Water
flow-rate is too high and/or the cold
water supply temperature is too low.
Reduce the flow-rate on the tap. Customer
By a qualified professional: use the
corner valve to regulate the flow-rate.
Check the flow-rate limiter or replace it
with a smaller one.
Servicing expert
The second stage in the appliance does
not switch on (the audible “clicking” is
missing).
Remove the filter in the tap and either
clean it or descale it.
Customer
Clean the filter in the corner valve
(Fig. 6, A 4).
Servicing expert
The continuous-flow heater switches off
during the drawing-off of water, resulting
in a reduction in the water temperature:
Swelling seal in the warm water tap A non-swelling sealing material must be
used in the warm water tap.
Customer
Winter operation:
The desired water temperature leaving
the tap is no longer reached.
The supply temperature has reduced. Reduce the water flow on the taps until
the desired water temperature is
reached.
Customer
This appliance is labelled in accordance with European
Directive 2012/19/EU concerning used electrical and
electronic appliances (waste electrical and electronic
equipment – WEEE).
The guideline determines the framework for the return
and recycling of used appliances as appli cable throughout
the EU.
Please ask your specialist retailer about current disposal
facilities.
Loading ...
Loading ...
Loading ...