Loading ...
Loading ...
Loading ...
4. Screw the legs into the leg holes by
hand. Use a wrench to finish turning
the legs until the diamond marking is
no longer visible.
5. Stand the dryer up. Move it close to its
final location. Leave enough room to
connect the exhaust vent.
For mobile home use
Gas dryers must be securely fastened to
the floor.
Mobile home installations require a Mobile
Home Installation Kit. See "Tools and
Parts" section for ordering
information.
Level Dryer
Check the levelness of the dryer. Check
levelness first side-to-side, then front-to-
back.
If the dryer is not level, prop up the dryer
using a wood block. Use a wrench to
adjust the legs up or down and check
again for levelness.
NOTE: It might be necessary to level the
dryer again after it is moved into its final
position.
Make Gas Connection
1. Remove the red cap from the gas
pipe. Move the dryer to its final
position.
2. Using a wrench to tighten, connect
the gas supply to the dryer. Use pipe
joint compound on all non-flared male
threads. If flexible metal tubing is
used, be sure there are no kinks.
NOTE: For L.R gas connections, you
must use pipe joint compound resistant
to the action of L.R gas. Do not use
TEFLON ®tape.
A combination of pipe fittings must be
used to connect the dryer to the existing
gas line. Shown following is a recom-
mended connection. Your connection
may be different, according to the supply
line type, size, and location.
!
1
2 8
1. s/. in. flexible gas connector
2. s/. in. dryerpipe
&Slain. to 3/sin. pipe elbow
4. s/. in. pipe-to41are adapter fitting
3. Open the shutoff valve in the supply
line. The valve is open when the han-
dle is parallel to the gas pipe.
1. Closed valve
2. Open valve
4. Test all connections by brushing on an
approved non-corrosive leak-detection
solution. Bubbles will show a leak.
Correct any leak found.
15
Loading ...
Loading ...
Loading ...