Loading ...
Loading ...
Loading ...
About the drying center.
i ! ! i /!
i ¸ i \ _
!iiil
WARNING!
• Do not overload the Dt?_ng Center. It lllay be damaged ifnlore than 20 lbs. are applied.
• Alwws store the Drying Center in a sad position so that it does not hit awone.
• Do not allow chil&en m pl W _ith the Drying Center.
The pole on the Dwing Center can be set at different heights. Line up the tabs on
the pole _ith the notch on the brackets (this will occur when the pole is parallel to
the control panel) and raise or lower the pole, resting the tab on the bracket at the
height you want.
The Drying Center can be mounted on either side of the dryer.
Toremove and transfer the Drying Centerto the opposite side:
[_] Remove the pole by raising it up. Make sure to line up the tabs on the pole with the
notches on the bracket.
[-_ Remove the four screws tl_at secure the bracket to the (hyer. Three of the screws xdll
be required to mount the bracket on the odmr side. The fourth screw at the top of din
side panel flange (shox,m in circled illustration) needs to be put back into its ori_nal
location.
[-_On the other side of the (hTer remove tt_e screw at tt_e top of tt_e side panel flange
(shown in circled illustration).
[-_ Turn the bracket upside down and attach it witt_ tt_e screw you just removed and
with the three screws that were removed fi'om the other side.
WaRNNa!
Make stu'e you use only dmse screws. Never use any long screws (must be less dmn 3/8") or
pointed screws.
N Insert tt_e pole into tt_e mounting bracket.
9
Loading ...
Loading ...
Loading ...