Loading ...
Loading ...
Loading ...
15
O
N
OFF
S
ET
W
ARMER
COLDER
˚
F/C
PRESS AND HOLD
POWER FAILURE - Flashing Amber
H
IGH/LOW TEMP - Red
P
RESS ON/OFF - Reset
ALARMS OFF - Steady Amber
T
ruProtect System
3
8
˚
F
14
SETTING THE CONTROLS
The temperature of our drawer unit ranges from 32°F to 45°F (0°C to 7°C).
TruProtect
™
“Basic” Function “Quick” Reference
Function
Function Access
Control Confirmation/Comment
Turn Unit On & Off
Adjust Temperature Set-Point
Display “Actual” Temperature
Select °F or °C Display
Black-Out Mode
Sabbath Mode
TruProtect™ System
Door Ajar Alarm
High/Low Temp Alarm
Power Failure Alarm
Reset Alarms
Disable/Enable TruProtect™
Defrost
Pressing and holding the keypad for 5-seconds will turn the unit “ON” or “OFF”.
To adjust temperature set-point, touch keypad and current set-point will be displayed.
Use the or keypads to adjust set-point temperature.
Display represents “real-time” monitoring of the compartment’s stored wine and/or
contents. Some temperature fluctuation around your desired set-point is normal.
Pressing the keypad will toggle the display between Fahrenheit and Centigrade
temperature display.
Display automatically shuts off when door is closed.
°F/C
Press and hold the keypad while pressing the keypad four (4) times.
°F/C
System monitoring is automatically enabled unless system has been disabled. (See below).
For Door Ajar alarm, TruProtect™ must be Enabled, (See “Disable/Enable TruProtect™”,
described below).
Note: Alarm may occur when changing set-points in excess of 10°F, and/or high usage,
this is normal. TruProtect™ must be Enabled , (See “Disable/Enable TruProtect™”,
described below).
Note: Alarm will occur upon initial installation, since unit was run at factory to verify quality,
this is normal. TruProtect™ must be Enabled , (See “Disable/Enable TruProtect™”,
described below).
Close door to reset Door Ajar alarm. Press keypad to reset all other alarms.
Press and hold the keypad for 5-seconds to “disable” or “enable” TruProtect™ System.
No action required - Defrost will automatically occur as required. will be displayed during the defrost function.
Display will be blank when refrigeration system is off. Lights will still function, but will time-out 15 minutes after
each activation, if door is left open or display lighting is on, to prevent overheating.
“Set” will appear in display when in set-point mode. “SET” mode will automatically time-out in 10 seconds if no
keypad activity occurs, or you may exit “SET” mode by pressing the keypad a second time.
SET
Temperature variation in “compartment air”, above and below set-point, is a normal effect of refrigeration system
cycling on and off. Stored items will not experience the full temperature swing of the compartment air due to the
dampening effect of their thermal mass.
dE
°F
=
In addition, the control panel is hidden when door is closed.
Display will flash four (4) times, then unit will enter Sabbath Mode. The display, audible alarms, LED and lights will
be disabled. Sabbath Mode will automatically time-out in 36 hours, or can be exited by repeating the enable keypad
routine.
LED displays steady green when TruProtect™ is enabled.
Audible alarm will sound 3-times every 30-seconds, LED will flash green.
Alarm will sound 6-times every minute and LED will flash red if product temperature excursions occur for a duration
outside acceptable limits.
LED will flash amber whenever power is interrupted to unit. No audible signal.
Note that although pressing the keypad will reset the alarms, the alarm will resume if the “alarm condition” still
exists.
LED displays steady green when alarm is enabled. LED displays steady amber when disabled.
ON
OFF
ON
OFF
SET
SET
SET
ON
O
FF
WARMER
COLDER
S
A
3
8
˚
F
4
˚
C
3
8
˚
F
Function
Function Access
Control Confirmation/Comment
Turn Unit On & Off
Adjust Temperature Set-Point
Display “Actual” Temperature
Select °F or °C Display
Black-Out Mode
Sabbath Mode
TruProtect™ System
Door Ajar Alarm
High/Low Temp Alarm
Power Failure Alarm
Reset Alarms
Disable/Enable TruProtect™
Defrost
Pressing and holding the keypad for 5-seconds will turn the unit “ON” or “OFF”.
To adjust temperature set-point, touch keypad and current set-point will be displayed.
Use the or keypads to adjust set-point temperature.
Display represents “real-time” monitoring of the compartment’s stored wine and/or
contents. Some temperature fluctuation around your desired set-point is normal.
Pressing the keypad will toggle the display between Fahrenheit and Centigrade
temperature display.
Display automatically shuts off when door is closed.
°
F/C
Press and hold the keypad while pressing the keypad four (4) times.
°
F/C
System monitoring is automatically enabled unless system has been disabled. (See below).
For Door Ajar alarm, TruProtect™ must be Enabled, (See “Disable/Enable TruProtect™”,
described below).
Note: Alarm may occur when changing set-points in excess of 10°F, and/or high usage,
this is normal. TruProtect™ must be Enabled , (See “Disable/Enable TruProtect™”,
described below).
Note: Alarm will occur upon initial installation, since unit was run at factory to verify quality,
this is normal. TruProtect™ must be Enabled , (See “Disable/Enable TruProtect™”,
described below).
Close door to reset Door Ajar alarm. Press keypad to reset all other alarms.
Press and hold the keypad for 5-seconds to “disable” or “enable” TruProtect™ System.
No action required - Defrost will automatically occur as required. will be displayed during the defrost function.
Display will be blank when refrigeration system is off. Lights will still function, but will time-out 15 minutes after
each activation, if door is left open or display lighting is on, to prevent overheating.
“Set” will appear in display when in set-point mode. “SET” mode will automatically time-out in 10 seconds if no
keypad activity occurs, or you may exit “SET” mode by pressing the keypad a second time.
SET
Temperature variation in “compartment air”, above and below set-point, is a normal effect of refrigeration system
cycling on and off. Stored items will not experience the full temperature swing of the compartment air due to the
dampening effect of their thermal mass.
dE
°F
=
In addition, the control panel is hidden when door is closed.
Display will flash four (4) times, then unit will enter Sabbath Mode. The display, audible alarms, LED and lights will
be disabled. Sabbath Mode will automatically time-out in 36 hours, or can be exited by repeating the enable keypad
routine.
LED displays steady green when TruProtect™ is enabled.
Audible alarm will sound 3-times every 30-seconds, LED will flash green.
Alarm will sound 6-times every minute and LED will flash red if product temperature excursions occur for a duration
outside acceptable limits.
LED will flash amber whenever power is interrupted to unit. No audible signal.
Note that although pressing the keypad will reset the alarms, the alarm will resume if the “alarm condition” still
exists.
LED displays steady green when alarm is enabled. LED displays steady amber when disabled.
ON
OFF
ON
OFF
SET
SET
SET
ON
OFF
WARMER
COLDER
S
A
3
8
˚
F
4
˚
C
3
8
˚
F
Loading ...
Loading ...
Loading ...