Loading ...
Loading ...
Loading ...
©2019 ACP, Inc.
Cedar Rapids, IA 52404
Page 5 of 11
Part No. 20267601
Original Instructions
Grounding/Earthing Instructions
Oven MUST be grounded. Grounding reduces risk of electric shock by
providing an escape wire for the electric current if an electrical short
occurs. This oven is equipped with a cord having a grounding wire with
a grounding plug. The plug must be plugged into an outlet that is
properly installed and grounded.
Consult a qualied electrician or servicer if grounding instructions are not completely understood, or if doubt exists as to whether
the oven is properly grounded.
Do not use an extension cord.
If the product power cord is too short, have a qualied electrician install a three-slot receptacle. This oven should be plugged into
a separate circuit with the electrical rating as provided in product specications (available at www.acpsolutions.com). When a
microwave oven is on a circuit with other equipment, an increase in cooking times may be required and fuses can be blown.
EXTERNAL EQUIPOTENTIAL EARTHING TERMINAL (EXPORT ONLY)
Equipment has secondary earthing terminal. Terminal provides external earthing connection used in addition to earthing
prong on plug. Located on outside of oven back, terminal is marked with symbol shown at right
Unpacking Oven
• Inspect oven for damage such as dents in door or inside oven cavity.
• Report any dents or breakage to source of purchase immediately.
Do not attempt to use oven if damaged.
• Remove all packing materials from oven interior.
• If oven has been stored in extremely cold area, wait a few hours before
connecting power.
Radio Interference
Microwave operation may cause interference to radio, television. Reduce or eliminate
interference by doing the following:
• Clean door and sealing surfaces of oven according to instructions in “Care and
Cleaning” section.
• Place radio, television, etc. as far as possible from oven.
• Use a properly installed antenna on radio, television, etc. to obtain stronger signal
reception.
Oven Placement
• Do not install oven next to or above source of heat, such as pizza oven
or deep fat fryer. This could cause oven to operate improperly and could shorten
life of electrical parts.
• Do not block or obstruct oven lters. Allow access for cleaning.
• Install oven on level counter-top surface.
• Place warning label in a conspicuous place close to microwave oven.
• Outlet should be located so that plug is accessible when oven is in place.
OVEN CLEARANCES
A. Allow at least 7” (17.78 cm) of clearance around top of oven. Proper air ow
around oven cools electrical components. With restricted air ow, oven may not
operate properly and life of electrical parts is reduced.
B. There is not an installation clearance requirement for the back of the oven.
C. Allow at least 1” (2.54 cm) of clearance around sides of oven.
D. Install oven so oven bottom is at least 3 feet (91.5 cm) above oor.
⚠
WARNING
To avoid risk of electrical shock or
death, this oven must be grounded
and plug must not be altered.
Installation
A
B
C
D
A
B
C
D
Loading ...
Loading ...
Loading ...