Loading ...
2
Install the Safety Reversing Sensor
Figures 2 and 3 show assembly of brackets and "C" wrap based on
the recommended installation of the sensors on each side of the
garage door as shown on page 1. Figures 4 and 5 are variations
which may fi t your installation requirements better.
Make sure the wraps and brackets are aligned so the sensors
will face each other across the garage door.
• Fasten the "C" wraps to the mounting brackets having square
holes, using the hardware shown in Figure 2.
• Connect each assembly to a slotted bracket, using the hardware
shown in Figure 3.
NOTE: the alignment of the brackets for left and right sides of
the door.
• Finger tighten the lock nuts.
• Use bracket mounting holes as a template to locate and drill (2)
3/16" diameter pilot holes on both sides of the garage door, 4"- 6"
above the fl oor but not exceeding 6" (15 cm). (See warning on
page 1.)
• Attach bracket assemblies with 1/4"x1-1/2" lag screws as shown
in Figure 3.
• Adjust right and left side bracket assemblies to the same distance
out from the mounting surface. Make sure all door hardware
obstructions are cleared. Tighten the nuts securely.
Garage
Floor
Inside
Garage
Wall
Alternate Floor Mount
Mounting Bracket
with Slot
Mounting Bracket
with Square Holes
"C" Wrap
Sensor
Indicator Light
Attach with
concrete anchors
(not provided)
"C" Wrap
Inside
Garage
Wall
Mounting Bracket
with Square Holes
Mounting Bracket
with Slot
Alternate Wall Mount
Sensor
Garage
Floor
Indicator Light
Mounting Bracket
with Slot
1/4"-20
Lock Nuts
1/4x1-1/2"
Lag Screws
1/4-20x1/2" Carriage Bolts
(with square shoulder)
Inside
Garage
Wall
"C" Wrap
Mounting Bracket
with Square Holes
Mounting Bracket
With Square Holes
#10-32x3/8"
Screws
"C" Wrap
#10-32
Lock Nuts
Figure 2
Figure 3
Figure 4
Figure 5
Lag Screw 1/4x1-1/2"
Screw
#10-32x3/8"
Lock Nut
#10x32
Staples
Carriage Bolts
1/4"-20x1/2"
Lock Nut
1/4"-20
HARDWARE SHOWN ACTUAL SIZE
Loading ...
Loading ...