Loading ...
Loading ...
Loading ...
Installing Shut-off Valve
(not included on some models)
Apply a small amount of pipe sealant to the tapered pipe
thread son the adapter and tighen into the man ifold. Install
the swivel connection end of the shut-off valve to the
straight threaded end of the adapter (pipe sealant is not
required) and tighten this connection. See photo.
REMOVAL OF SHIPPING BOARDS AND
INSTALLATION OF RUBBER FEET
(not included on some models)
.
It may be necessary to brace or support
one end of the outfit when attaching the
wheels, wheel plates, and the rubber
foot strip, because the air compressor
will have a tendency to tip,
Tip the aircompressor toward the intake muffler side.
Remove (2) screws with washers securing the upper
shipping board with 3/8" socket wrench. Reusethe (2)
screws to attach (2) of the rubber feet. Tighten se-
curely.
.
Carefully remove (2)screws with washers securing the
lower shipping board. Supporting the outfit at this
point may be necessary to prevent tipping. Again
reuse the (2)screws to attach the remaining (2) rubber
feet. Tighten securely.
3. Discard the (2) shipping boards and (4) washers.
INSTALLATION BREAK-IN PROCEDURES
Location of the Air Compressor
Locate the air compressor in a clean, dry and well
ventilated area. The air filter must be kept clear of
obstructions which could reduce air delivery of the air
compressor. The air compressor should be located at
least 12" away from the wall or other obstructionsthat will
interfere with the flowof air. The air compressor head and
shroud are designed to allow for proper cooling.
If humidity is high, a Sears air filter can be installed on the
air outlet adapter to remove excessive moisture. Follow
the instructions packaged with the air filter for proper
installation.
Lubrication and Oil
This unit needs no lubrication or oiling.
Loading ...
Loading ...
Loading ...