Loading ...
Loading ...
Loading ...
Ensurethereisahexjamnutthreadedallthe
way up the threaded portion of the Z fitting;
extras are supplied inthe hardware pack. See
Figure 10.
Place the clutch grip in the raised (up) position.
Outer
of cut-out
\
Hex Jam
Nut "_ '
Z Fitting
Nut
_(Vi_ii_i_theont rol panel)
Figure 10
Swing the left auger cable up making sure the
cable is routed correctly in the cable roller
guides located at the lower rear of the unit.
Hold the end of the cable at the barrel so the
ferrule turns freely without twisting the cable.
Thread the ferrule on to the Z fitting. You may
have to pull on the cable slightly to relieve
tension. Keep the ferrule turning without twisting
the cable.
You will reach correct adjustment when there is
minimal slack in the cable but it is nottight. Hold
the flats on the ferrule with pliers and tighten the
jam nut against the ferrule. CAUTION: Cables will
become loose ifyou do nottighten the jam nut.
A
WARNING: There must not be any tension
on either clutch cable with the drive or auger
clutch grip in the disengaged (up) position.
These clutches are a safety feature. Do not
override their function.
Attaching Shift Rod
Placethe shiftlever inthe sixth(6) speed.
Placethebent end of the shift rod into thehole in
the shift arm assembly. See Figure 11.Secure
with 5/16flat washer and hairpin clip from group D
of the hardware pack.
Thread ferrule (included in group D) from the
right side onto the other end ofthe shift rod till it
lines up with the upper hole in the shift lever
(beneath the handle panel). While aligning the
ferrule, push down on the shift rod and the shift
arm assembly as far as it will go.
• Once the ferrule slides into the hole, turn it
counter-clockwise one more full turn and insert it
in the hole in the shift lever. For proper
positioning of the ferrule and the associated
hardware, see Figure 11.
Shift Chute Distance
Lever Control
Drive Auger
Clutch
Upper
Flat
Shift Washer
Lever
Clip
Rod
Hair Assembly
Clip
Figure 11
NOTE: You may have topull the shift lever out of the
sixth speed position and move it towards the fifth
speed position until the ferrule slides into the hole
without force.
Secure theferrule to the shift lever with another
5/16 flat washer and hairpin clip from group Dof
the hardware pack. See Figure 11.
Make certain to check for correct adjustment of
the shift rod as instructed in the Adjustment
section before operating the snow thrower.
Attaching Turn Triggers
Check and make sure that the right hand trigger
cable is routed in front of the traction drive cable.
• Feedthetriggercableup throughthe outersideof
theslot inthe handle panel. Donot feedthecable
throughthesame sideof theslotas theZ fitting.
• Placethe cable barrel fitting into the hole inthe
trigger. You can find the triggers and associated
hardware in group Hof the hardware pack. See
Figure 12.
Trigger
Assembly /
Inner Cable _'N_
Slot
Trigger
Housing
/
Cable snaps in at
this end
Figure 12
9
Loading ...
Loading ...
Loading ...