Loading ...
Loading ...
Loading ...
TO ASSEMBLE GRASS CATCHER
1. Put grass catcher frame i_o grass bag
with rigidpart of bag on the bottom.
Make sure the frame handle is outside
ofthe bag top.
2. Slip vinyl bindings over frame.
NOTE: Ifvinyl bindings are too stiff,hold
them in warm water for a few minutes. If
bag gets wet, let it dry before using.
ACAUTION: Do not run your lawn mower
without clipping deflector or approved
grass catcher in place. Never attemptto
operate the lawn mower with the rear
door removed or propped open.
Catcher__
frame"_
handle
ENGINE
ENGINE SPEED
Your engine speed has been factory set.
Do not attempt to increase engine speed
or it may result In personal injury, ffyou
believe that the engine is runningtoo fast
or too slow, take your lawn mower to a
Sears or other qualified service center for
repair and adjustment.
CARBURETOR
Your carburetor has a oon-adjustable
fixed mainjet for mixturecontrol. Ifyour
engine does not operate properly due to
suspected carburetor problems, take your
lawn mower to a Sears or other qualified
service center for repair and/or adjust-
ment.
IMPORTANT: Never tamper with the
engine governor,which is factory setfor
proper engine speed. Overepeeding the
engine above the factory high speed
setting can be dangerous. If you thinkthe
engine-governed high speed needs
adjusting, contact a Sears or other
qualified service center, which has proper
equipment and experience to make any
necessary adjustments.
Immediately prepare your lawn mower for
storage at the end ofthe season or ifthe
unitwill notbe used for 30 days or more.
LAWN MOWER
When lawn mower isto be storedfor a
period oftime, clean it thoroughly,remove
all dirt,grease, leaves, etc. Store in a
clean, dryarea.
1. Clean entire lawn mower (See
"CLEANING" in the Maintenance
section of this manual).
2. Lubricate as shown in the Mainte-
nance section of this manual.
3. Be sure that all nuts, bolts, screws,
and pins are securely fastened.
Inspect moving partsfor damage,
breakage and wear. Replace if
necessary,
4. Touch up all rusted or chipped paint
surfaces; sand lightly before painting.
15
Loading ...
Loading ...
Loading ...