Loading ...
Outlining your eyebrows,
moustache, or beard (Fig. 6)
1
Apply the tip of the outer blade to
the hair (eyebrow, moustache or
beard) you would like to cut.
2
Cut the hair by moving the
appliance slowly against the
direction of hair growth.
▪You cannot trim the hair to length with
this head.
▪It is not suitable for the hair below
0.5mm(1/64˝).
Maintenance
•
Make sure that the main body is turned off.
• After cleaning, be sure to store with the
blades, the trimmings box and the
protective cap attached.
How to clean
►With water
1.Apply some hand soap and some
water to the outer blade.
2. Turn on the power and turn off the
powerafter10seconds.(Fig.7‑1)
▼ ▼
To remove light dirt
To remove heavy
dirt
3.Open the water
inlet and turn on
the power again.
▪
If the trimmings
box is removed,
open the water
inlet after
attaching the
trimmings box.
4.
Run water down
the water inlet,
rinse well and turn
off.(Fig.7‑
2
)
3.Remove the
head,the blades
and the
trimmings box.
4.Rinse them with
running water.
•
Coverthe
drainage outlet
of washbasin to
prevent the
inner blade from
owingaway.
(Fig.7‑
3
)
▼ ▼
5. Wipe off the water with a dry cloth and
dry it well.
▪It will dry faster with the blades and
the trimmings box removed.
Notes
• Note the following precautions to avoid
malfunction and damage.
• Do not use hot water or any
detergents other than hand soap.
• Do not wipe with thinner, benzine,
alcohol etc.
►With the cleaning brush (Fig. 8)
1.Remove the head, blades and the
trimming box.
2. Brush off any hair trimmings from the
head, blades and the trimming box.
▪
Be careful not to deform the inner blade.
▪Becarefulnottodamagethelter.
How to open and
close the water inlet
►Open
Rotatethewashswitchringuntilits“ ”
markalignswiththe“ ” mark of the
head to open the water inlet. (Fig. 9-1)
►Close
Rotatethewashswitchringuntilits“ ” mark
alignswiththe“ ” mark of head. (Fig. 9-
2
)
Removing and mounting
the trimmings box
►Remove (Fig. 10‑1)
Rotatethewashswitchringuntilits“ ”
markalignswiththe“ ” mark of the head.
►Mount (Fig. 10‑2)
1.Alignthe“ ” mark of the trimmings
boxwiththe“ ” mark of the head.
▪Becarefulnottodamagethelter
with the shaft (c).
2. Rotate the wash switch ring until its
“ ”markalignswiththe“ ” mark of
the head.
Removing and mounting
the blade (Fig. 11)
►Outer blade
Remove
Rotate the outer blade in the direction of
the arrow and remove the blade. (1)
Mount
Insert the head’s shaft (d) into the hole
of the inner blade.
Rotatetheouterbladetoalignits“ ”mark
withthe“ ” mark of the head. (
2
)
►Inner blade
Remove
Pull to remove the inner blade.
Mount
Insert the inner blade straight into the
outer blade.
Troubleshooting
Problem Action
The cutting
performance
has reduced.
Replace the blade.
Cleantheinnerblade.
There is an
odd odour.
Blade does not
move/rotate
smoothly.
The suction
power is low.
Cleanthetrimmings
box.
Closethewaterinlet.
If the problems still cannot be resolved,
contact your dealer or a service center
authorized by Panasonic for repair.
Personal Care & Beauty Care Products
FOR USA ONLY
30‑Day Quality
Satisfaction Guarantee
Ifyouaredissatisedwithany
PanasonicPersonalCare&Beauty
CareProductsforanyreason,simply
return it to the place of purchase with a
dated proof of purchase, in the original
packaging, with all accessories, parts
andinstructions,within30daysofthe
date of purchase, for a full refund, or
callPanasonicat1‑800‑338‑0552.
Abuse or misapplication of this product
voids the guarantee.
PRODUCT REGISTRATION
(U.S. customers only)
Go to www.panasonic.com/register and
register your product now to receive
thesebenets:
Safety Notication
We contact our customers in case of recall
Owner Verication
Proof of purchase in case of product
theft or loss
Efcient Warranty Service
In case there is a problem with your product
Special Offers and Promotions from
Panasonic
FOR YOUR CONVENIENCE, WE HAVE
ESTABLISHED A TOLL‑FREE (IN USA
ONLY) NATIONAL ACCESSORY
PURCHASE HOTLINE AT 1‑800‑332‑5368.
Printed in Thailand
ER971WCNT11X
F0222‑0
© Panasonic Corporation 2022
F EN
IN USA CONTACT:
Panasonic Corporation of North America
TwoRiverfrontPlaza,Newark,NJ07102‑5490
Service • Assistance • Accessories
Call 1‑800‑338‑0552 (In USA)
https://shop.panasonic.com/personal‑care
https://shop.panasonic.com/support
https://www.panasonic.com
ER-CNT1_US_PR.indd 2 2022/02/21 15:08:47