Loading ...
Loading ...
Loading ...
TROUBLESHOOTINGCHART
REMEDY
• Allow tip of line to do the cutting.
• Contact your Sears Service Ctr.
• Check Breaker Box.
• Remove debris.
• Check line routing.
TROUBLE
Semi-automatic
head stops
under a load or
does not turn
when switch is
pressed=
Line does not
advance or
breaks while
cutting.
Line welds
onto spool=
Line releases
continuously.
Line usage is
excessive.
CAUSE
• Crowding trimmer line
against material being
cut.
• Electrical failure.
• Thrown circuit breaker
• Debris stopping head
• Line improperly
routed in head.
• Line improperly
wound onto spool.
• Incorrect line size
• Not enough line
outside of head.
• Dirt buildup on cover=
• Line size is incorrect.
• Incorrect spool.
• Line is being crowded
against material being
cut.
• Line improperly
routed in head.
• Spool damaged.
• Line improperly
routed in head.
• Line size is incorrect.
• Crowding line against
material being cut.
• Spool teeth worn
or damaged.
• Rewind line tightly and evenly.
• Use only .065 in. diameter line.
• Pull 4 Inches of line outside of
head.
• Clean cover.
• Use only .065 in. diameter line.
• Replace with correct spool.
• Cut with tip of line fully extended.
• Check line routing.
• Replace spool=
• Check line routing.
• Replace spool.
• Cut with tip of line fully extended.
• Replace Spool
Line pulls • Too little line outside • Remove cover and pull 4 inches
back into of head. of line outside of head.
head. • Line size incorrect= • Use only .065 in. diameter line=
lO