Loading ...
Loading ...
Loading ...
Installation
Note on installation
• Ensure the correct layout of the exhaust air duct as well as an adequate supply of intake air.
Exhaust air requires intake air.
• Avoid routing the exhaust air pipeline to the side through the flue casing.
• Planning features for non-destructive de-installation and maintenance of the appliance.
– Do not route telescopic casing in suspended ceilings.
– Avoid silicon joints between the telescopic casing and the appliance.
– All plastering, plasterboarding, wall papering or painting work is to be carried out prior to installing the appliance.
Installing
4 × S1 (M4 × 15 mm)
36 × S2 (ø 3.5 × 6 mm)
6 × S3 (ø 5 × 40 mm)
1. Align motor housing A so cables L are at the front. Put
motor housing A on hood body B. Ensure that no
cables are trapped.
WARNING: Protect the glass cover!
S1
S1
A
B
L
2. Screw 2 screws S1 (M4 × 15 mm) to both the front
side and the back side of the motor housing A.
3. Lay hood on its back. Open glass cover, supporting it.
S2
S2
4. Remove grease filter.
5. Screw 6 screws S2 (ø 3.5 × 6 mm) in hood body B.
Installation instructions
J63004.113-0
Range hood DIPQG10/DIPQG12
02.09.14
Island hood
Operating mode: Extraction/recirculation
4
Loading ...
Loading ...