Loading ...
Loading ...
Loading ...
Connections
SERIAL Terminals connection
The SERIAL terminal is used when the Plasma Display is controlled by a computer.
COMPUTER
Ferrite core
(supplied)
Ie ®]
RS-232C _SEFtlAL_
Lees than
7" 7/8(20 cm)
Pin layout for RS-232C
Notes:
(1) Use the RS-232C cable to connect the computer to the Plasma Display.
(2) The computers shown is for example purposes only.
(3) Additional equipment and cables shown are not supplied with this set.
The SERIAL terminal conforms to the RS-232C interface specification, so that the Plasma Display can be controlled by
a computer which is connected to this terminal.
The computer will require software which allows the sending and receiving of control data which satisfies the conditions
given below. Use a computer application such as a programming language to software. Refer to the documentation for
the computer application for details.
Communication parameters
Signal level
Synchronization method
Baud rate
Parity
Character length
Stop bit
Flow control
RS-232C compliant
Asynchronous
9600 bps
None
8 bits
1bit
RS-232C Conversion cable
D-sub 9-pin female
®
®
@
®.®
@
®
®.@
Details
RXD
TXD
GND
Non use
3 Shorted
NC
Basic format for control data
The transmission of control data from the computer starts
with a STX signal, followed by the command, the
parameters, and lastly an ETX signal in that order. If there
are no parameters, then the parameter signal does not
need to be sent.
iPtp2,P3LP41P,
Lco,on L Parameter(s) L End
tart L 3-character (1 - 5 bytes) (03h)
(02h) command (3bytes)
Note:
(1) If multiple commands are transmitted, be sure to wait
for the response for the first command to come from
this unit before sending the next command.
(2) If an incorrect command is sent by mistake, this unit will
send an "ER401" command back to the computer.
Command
Command
PON
POF
AVL
i AMT
IIS
DAM
Parameter
None
None
0
1
None
VID
YP1
RG1
None
NORM
ZOOM
FULL
JUST
SELF
Control details
Power ON
Power OFF
Volume 00 - 63
Audio MUTE OFF
Audio MUTE ON
Input select (toggle)
AV Mode
Component/ RGBmode(processedasa
Y/PB/PBorRGBsignalsassetbythisunit}
PC mode
Screen mode select (toggle)
NORMAL (4:3)
ZOOM
FULL
JUST
Panasonic AUTO
With the power off, this display responds to PON command only.
17
Loading ...
Loading ...
Loading ...