Loading ...
Loading ...
Loading ...
Connections
PC Input connection
COMPUTER
[ "" •
ii
L
Conversion adapter (if necessary)
_ PC cable
Connect a cable which matches
D-sub 15p
Ferrite core 'bLessthan _,
(supplied) _ 7" 7/8 _---
__ (20 cm) ,,
Audio
, 1/8" (3mm)stereo plug
the audio output terminal on the computer.
Installing the ferrite core
,o enIIback the tabs
_ (intwoplaces)
3
_._ PrthreoSLgthenC_bcllese
Notes:
(1) Computer signals which can be input are those with a horizontal scanning frequency of 15.5 to 110 kHz and vertical
scanning frequency of 48 to 120 Hz. (However, signals cannot be displayed ifsignals exceeding 1200 lines will not
be displayed properly.)
(2) The display resolution isa maximum of 640 × 480 dots when the aspect mode is set to "NORMAL", and 852 x 480
dots when the aspect mode is set to "FULL". If the display resolutionexceeds these maximums, it may not be
possible to show fine detail with sufficient clarity.
(3) The PC input terminals are DDCl/2B-compatible. If the computer being connected is not DDCl/2B-compatible, you
will need to make setting changes to the computer at the time of connection.
(4) Some PC models cannot be connected to the set.
(5) There is no need to use an adapter for computers with DOSN compatible D-sub 15P terminal.
(6) The computer shown in the illustration is for example purposes only.
(7) Additional equipment and cables shown are not supplied with this set.
(8) Do not set the horizontal and vertical scanning frequencies for PC signals which are above or below the specified
frequency range.
Signal Names for D-sub 15P Connector
Pin layout for PC input
terminal
Pin No.
(b
@
®
®
®
Signal Name
R
G
B
GND (Ground)
GND (Ground)
Pin No.
®
®
®
®
®
Signal Name
GND (Ground)
GND (Ground)
GND (Ground)
NC (notconnected)
GND (Ground)
Pin No.
@
@
@
@
@
Signal Name
GND (Ground)
SDA
HD/SYNC
VD
SCL
16
Loading ...
Loading ...
Loading ...