Loading ...
Loading ...
Loading ...
Installation
@
_WARNING
ALL DRAWERS CAN TiP
INJURY COULD RESULT
INSTALL ANTI-TIP
BRACKET PACKED
WITH UNIT
SEE INSTRUCTIONS
Floor Mount Installation
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii_
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii_
installation does not allow marking the rear
corner of the cabinet, then make temporary
lines on the floor marking the front corner of
the cabinet, excluding the drawer. Slide the
beverage center out of the way. From the
temporary lineextend the sidewall line back
211/¢,(54.6cm)as shown in Figure 7.
4 Align the anti-tip bracket to the marks
on the floor so the side of the bracket
lines up with the side of the cabinet
mark, and the "V" notches on the anti-tip
bracket line up with the end of the 211/¢'
(54.60m) line (Rear of cabinet line).
5 Fasten the anti-tip bracket to the floor
using the supplied screw. (See Figure 7).
6 Slide the cabinet back into position, making
sure the rear cabinet leveling leg slides
under the anti-tip bracket engaging the slot.
Anti.Tip "i re 6
Bracket t- gu
The anti-tip bracket is to be located on the
floor in the left or right rear corner of the
beverage center as shown in Figure 6.
Step by step instructions for locating
21 112"
the position of the bracket: (54.6cm)
1 Decide where you want to place the
beverage center, Slide it into place, being
careful not to damage the floor, leaving 1"
(2.5cm) of clearance from the rear wall to
allow room for the anti-tip bracket.
2 Raise the rear leveling legs approximately
W' (6mm) to allow engagement with the
anti-tip bracket. Level the unit by adjusting
all the leveling legs as required. Turning the
leveling leg counterclockwise will raise the
unit and clockwise will lower the unit.
3 Make sure the beverage center is in the
desired location, then mark on the floor the
rear and side corner of the cabinet where
the anti-tip bracket will be installed, if the
Figure 7
Rear Leveling leg
1/2"
(54.6cm)
are 7a "V" notches
in bracket
in bracket
Loading ...
Loading ...
Loading ...