Loading ...
Loading ...
Loading ...
Before You Call for Service
Ifthe unit appears to be malfunctioning,
read through this manual first, Ifthe problem
persists, check the Troubleshooting Guide
below. Locate the problem inthe guide and
referto the cause and its remedy before calling
for service.The problem may be something
verysimple that can be solved without a
service call.Consulting or contracting a
qualified service technician may be necessary.
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
If Service is Required
Contact the dealer where you purchased
the unit if service is required. State the
model and serial number and explain the
problem. The model and serial number
plate is located on the ceiling of your unit.
Ifyou do not know the name of the selling dealer
or a localservicecompany, you can check
online at www.electrolux:appliances.corn or
call 1-877-435-3287.
Unit not cold
enough.
Adjust
temperatures
(see "Adjusting
the Temperature"
in the "Start-Up
and Temperature
Control" section).
• Control set too warm.
Light staying on.
Airflow to front grille
blocked.
Door gasket not
Adjust temperature colder, Allow 24
hours for temperature to stabilize.
Turn off manual light control.
See "Operation" section.
Airflow must not be
obstructed to front grille. See
"Installation" section.
Adjust door gasket.
sealing properly.
Unit too cold. • Control set too cold. • Ad ust temperature warmer.
Contents of unit Allow 24 hours for temperature
too cold/frozen, to stabilize.
Ad ust temperatures
(see "Ad usting
the Temperature"
in the "Start-Up
and Temperature
Control" section).
No interior light. = Failed LED assembly. • Contact a qualified Electrolux
Service Technician.
Light will not go = Manual light control = Turn oft manual light control.
out when door is is ON. See "Operation" section.
closed. = Door switch not = Check for proper door
making contact, alignment.
Alarm(s) will not • Door is ajar. = Press "Power" key to
shut oft. acknowledge alarm.
• Power has failed. • Ensure door is closed firmly.
= Internaltemperature is • Allow24 hours for temperature
too high. to stabilize.
Power is not = Circuit breaker has = Verify electrical supply. See
restored after tripped. "Installation" section.
power failure.
Door does not = Door hinges are = Loosen hinges and re-align
close properly, misaligned, door. metighten hinges.
• Door gasket is not = Turn gasket 180 °.
sealing properly.
Loading ...