Loading ...
Loading ...
Loading ...
MAINTENANCE (Cont'd.)
WHEN SERVICING USE ONLY IDENTICAL REPLACEMENT PARTS
GENERAL
Only the parts shown on parts list, page fifteen, are
intended to be repaired or replaced by the eustomer=
All other parts represent an Important part of the
double Insulated system and should be serviced on-
ly by a qualified Sears service technician
Avoid using solvents when cleaning plastic parts.
Most plastics are susceptible to various types of
commercial solvents and may be damaged by thetr
use. Use clean sloths to remove dirt, carbon dust,
etc
When electric tools are used on fiberglass boats,
sports cars, etc. it has been found that they are sub-
jest to accelerated wear and possible premature
failure, as the fiberglass ch_ps and gdndlngs are
highly abrasive to bearings, brushes, commutators,
etc. Consequently it is not recommended that this
tool be used for extended work on any fiberglass
material During any use on fiberglass it is extremely
important that the tool is cleaned frequently by blow-
ing with an air jet. ALWAYS WEAR SAFETY GOG.
GLES, SAFETY GLASSES WITH SIDE SHIELDS, OR
A DUST MASK BEFORE BEGINNING POWER TOOL
OPERATION OR BLOWING DUST_
HELPFUL HINTS
• Always clamp workplece securely before routing
o A safe operator Is one who thinks ahead
= Always wear eye protection when routing
o Make set-up adjustments carefully Then double check. Measure twice and cut once
Q Keep cutters clean and properly sharpened
• Don't let familiarity make you careless
,, Study all safety rules and do the job safely
• NEVER place your hands In jeopardy
o Make certain clamps can't loosen while In use
= Test difficult set-ups on scrap -- Don't waste lumber
• Plan each operation before you begin.
=' THINK SAFETY BY THINKING AHEAD.
Page 12
Loading ...
Loading ...
Loading ...