Loading ...
Loading ...
Loading ...
REPLACING BATTERY
_WARN_NG: Do not short battery
temsinais by ai/owing a wrench or any
other object to contact both term na/s at
the same tme. Before connect ng ba£tery,
remove meta brace ets, wristwatch bands,
dngs, etc_
Pos tive termir,,a must be connected
f_st to prevent sparking from accidental
1 Lift hood to raised position
2 Disconnect BLACK battery cabie (A)
then RED battery cabb and carefl_y
_emove battery from tractor,
3. hstaH new battery with termina}s in
same position as oid baSery_
4 First connect RED battery cable (B) to
positive (+) battery terminal wth hex
bolt and keps nut as shown Tightens
securely_ SHde termina_ cover (C) over
terminal
5. Connect BLACK ground ng cable to
negative (o) battery term ha/with re_
maining hex bolt and keps nut, Tighten
6. C_ose hood_
TO REPLACE FUSE
Replace with 30 amp automot ve_type
p/ugoin fuse. iThe fuse hoider s ocated
behnd the dash
TO REMOVE HOOD AND GRILL ASo
1_ Raise hood
2 Unsnap head_ght wire connector_
3_ Stand n fivsnt of tractor Grasp hood at
sides, tiit toward er gine and Iifl off of
tractor
4 When replacing hood, be sure to re
connect the headlight wire connector.
\
Cabte
Positive
Cable
\
_O REPLACE IGHT BULB
1 Rabe hoed,
2 Remove bulb holder from the hole in
the backside of the griii.
3. Replace buib in holder and instai! buib
holder securely back into the hoie in
the backside of the gdI.
4 Close hood
_NTERLOCKS AND RELAYS
Loose or damaged wiring may cause
your tractor te run poody, stop running, or
prevent it frem startin%
o Check wirng, See e_ectdca wiring
diagram n the Repair P_rts section.
Maintenance repair, or replacement of
the em ssion eentro_ devices and systems,
whch are being done at the customers ex_
pense, may be pedermed W any non read
engne repar estabIishrnent or individua _
Warranty repa rs must be pedorr ed by an
authorized engine manufactu_eCs service
outlet
_f ;your engne does not operate propedy
due te suspected carburetor prob[erns,
take !lout tractor to a Sears or other
%_aiif ed service center for repair and/or
High speed stop is factory adiusted Do
not ad}ust o damage may resu_L
#_PORTANT: Never tamper wth the
engine governor, which is _act.ery set
for proper engine speed. OverspeeG
ng the engne above the factory high
speed sett ng can be dangerou& If you
think the engine_govemed high speed
needs adjust n G contact a Sears or other
%_al fled service center,, which has proper
eq_Jipment and experience to make any
necessary ad}ustments.
Loading ...
Loading ...
Loading ...