Loading ...
Loading ...
Loading ...
HOW TO ADJUST THE BRAKE PAD
The brake pad is adjusted at the factory
and a periodic adjustment is not neces-
sary.
IMPORTANT: An adjustment is only
necessary if the brake pad has become
loose or has been removed. To adjust,
proceed as follows:
1. Remove the top cover. See "How To
Remove The Top Cover".
2. Remove the belt cover. See "How
To Remove The Belt Cover".
.
.
Tie the auger drive lever to the han-
dle. This will engage the drive sys-
tem.
Loosen the screw and nut on the
brake pad arm (Figure 14).
5. Set the clearance between the
brake pad and the drive belt to 1/8
inch.
6. Tighten the screw and nut on the
brake pad arm.
idler Pulley
Screw
Brake Pad
Engine Pulley
.;:-' Belt Guide
Brake Roller
Drive Belt
Figure 14
F-O01128M 18
Loading ...
Loading ...
Loading ...