Loading ...
Loading ...
Loading ...
page 4
Remove 1 motor mounting screw from hook end
of motor assembly. Remove the other 2 motor
mounting screws from hanging bracket. Save
motor mounting screws for later use.
Lift motor assembly to hanging bracket and slide
hook end (with single screw hole) into square
opening on hanging bracket (see diagram at
right). This will allow the motor assembly to hang
out of the way while wiring.
Tip: Seek the help of another person to hold the
stepladder in place and to lift the fan up to you
once you are set on the ladder.
6. Wiring.
motor assembly
*
WHITE
WHITE
BLACK
BLACK
BLUE
GROUND (GREEN OR BARE)
GREEN
5. Preparation for Wiring.
hanging
bracket
hanging
bracket
motor assembly
motor
mounting
screws
hook end
WARNING: Turn off circuit breakers to current fixture
from breaker panel and be sure switch is turned to
the OFF position.
NOTE: See instructions above (Section 5) in order to
temporarily hang fan on hanging bracket during
wiring.
CAUTION: Be sure outlet box is properly grounded and
that a ground wire (GREEN or Bare) is present.
Make sure all electrical connections comply with Local
Codes or Ordinances and the National Electrical Code. If
you are unfamiliar with electrical wiring or if the
house/building wires are different colors than those
referred to in the instructions below, please use a
qualified electrician.
When fan is secured in place on the hanging bracket,
electrical wiring can be made as follows:
Connect BLACK and BLUE wire from fan to BLACK
wire from ceiling with wire connector provided.
Connect WHITE wire from fan to WHITE wire from
ceiling with wire connector provided.
Connect all GROUND (GREEN) wires from fan
together to BARE/GREEN wire from ceiling with wire
connector provided
If you intend to control the fan light with a separate
light switch, connect BLUE wire from fan to the
BLACK supply from the independent switch.
* Wrap each wire connector separately with electrical
tape as an extra safety measure.
Loading ...
Loading ...
Loading ...