Loading ...
Loading ...
Loading ...
[ENGLISHI
Notices and Safety Instructions
9.VENTILATION:
Slots and openings inthe cabinet are provided for
ventilation to ensure retiabte operation of
the CAMCORDER and to protect itfrom overheating.
These openings must not be blocked or covered.
Never place your CAMCORDER on a bed, sofa, rug, or
other similar surface: on or near a radiator or heat
register.
This CAMCORDER should not be placed ina built-in
installationsuch as a bookcase or rack untess
proper ventilation is provided or the manufacturer's
instructionshave been adhered to.
10. POWER SOURCES:
The CAMCORDER should be operated only from the type
of power source indicated on the label.
Ifyou are not sure of the type of power supply at your
home, consult your appliance dealer or local power
company.
A CAMCORDER is intended to be operated from battery
power, or other sources, refer to the operating instructions.
11.GROUNDING OR POLARIZATION:
This CAMCORDER may be equipped with either a
polarized 2-wire AC line plug (a plug having one btade
wider than the other) or a 3-wire grounding type plug,
a plug having a third (grounding) pin.
Ifyou are unable to insert the plug fully into the outlet,
try reversing the plug, Ifthe plug still fails to fit,
contact your electrician to replace your outlet.
Do not defeat the safety purpose of the polarized piug.
12. POWER-CORD PROTECTION:
Power-supply cords should be routed so that they are not
liketyto be walked on or pinched by items placed upon or
against them, paying particular attention to cords or plugs,
convenient receptacles, and the point where they exit from
the unit.
13. OUTDOOR ANTENNA GROUNDING:
If an outside antenna or cable system is connected to the
CAMCORDER, be sure the antenna or cable system is
grounded to provide some protection against voltage
surges and built-up static charges, Section 810 of the
National Electrical Code, ANSt/NFPA No. 70-I984,
provides informationwith respect to proper grounding of
the mast and supporting structure, grounding of the
lead-in wire and supporting structure, grounding of the
mast and supporting structure, grounding of the lead-in
wire to an antenna discharge unit, size of grounding to
conductors, location of antenna-discharge unit, connection
to grounding electrodes and requirements for the
grounding electrode.
See figure below.
A=
Loading ...
Loading ...
Loading ...