Loading ...
Loading ...
Loading ...
1. Press and hold both of the "SET" buttons
([] & Pq)together until the green indicator
light blinks (about 5 seconds).
2. All close and open travel limit settings are
erased. Then follow the steps above to
reprogram close and open travel limits.
.......... ne doo_
NOTE" TY,_'_o/:J®s"ey w F .o_'_'cos® '""
I
The force adjustments and limit switch settings
MUST BE COMPLETED before testing.
1. Testing.
, Open garage door using Wall Control.
- Place a 2" x 4" board (laid flat) under center
of garage door opening (FIG. 6-5).
, Close door using Wall Control.
, When door contacts board, the door must stop
(within 2 seconds) and reverse direction
returning to open position.
2. Adjustment.
, If the door does not properly reverse.
- Check to see if door has "close" limit
programmed. It should not have reached its
"close" limit before hitting board.
-If the door STOPS but does not reverse,
decrease "CLOSE FORCE" control _
setting slightly (turn it counter-clockwise).
, Test again. Repeat as necessary until door
reverses upon contacting board.
2 PN# 37026500123 05/15/2009
Loading ...
Loading ...
Loading ...