Loading ...
Loading ...
Loading ...
PROBLEM
o'ssofp wer
TROUBLESHOOTING CHART
3AUSE
o
Poor cut- uneven
, ,,,,,,, •
vibration
Starter rope hard
to pull
Grass catcher
not filling (if so
equipped)
Hard to push
Rear of lawn mower housing
or c_ing blade dragging
in heavy grass.
• Cutting too much grass.
• Dirty airfilter.
• Buildup ol grass, leaves,
and trash under mower.
Too much oilin engine.
• Walldngspeed too fast.
-Wom, bent or loose blade°
• Wheel heights uneven.
. Buildup of grass, leaves
and trashunder mower.
• Wom, bent or loose blade.
- Bent engine crankshaft.
= Engine flywheel brake ison
when control bar isreleased_
o Bentengine crankshaft.
° Blade adapter broken.
• Blade dragging in grass.
• Cutting height too low.
, [.fit on blade wom off.
• Catcher not venting air.
• Grass is too high or wheel
height is too low.
• Rear of lawn mower
housing or blade dragging
in grass.
• Grass catcher too full,
• Handle height position not
right for you.
CORRECTION
11,,,J, ,, 1,,, : .......
° Setto "Higher Cut"
position.
, Set to "Higher Cut"
position.
° Clean/replace air fitter_
• Clean underside of mower
housing.
• Chec k oil level.
• Cut at slower walking
• Replace blade. Tighten
blade bolt
° Set all wh_=_lsat same
height
° Clean underside of
mower housing.
, Replace blade. Tighten
blade bolt.
- Contact an authorized
service center.
Depress control bar to
upper handle before
pulling starter rope.
' - Contact an authorized
service center.
= Replace blade adapter.
= Move lawn mower to cut
grass or to hard surface
to start engtne.
° Raise cutting height.
• Replace bladeo
= Clean grass catcher.
, Raise cutting height.
° Raise rear of lawn mower
housing one (1) setting
higher.
• Empty grass catcher.
° Adjust handle height to
suit.
IR
Loading ...
Loading ...
Loading ...