Loading ...
Loading ...
Loading ...
33
Setting the Ext. In Setup
• Set the method of playback of the analog input signal connected to the Ext.In-1 and Ext.In-2 terminal.
1
At the System Setup Menu select “Ext.In Setup”.
2
Switch to the Ext.In Setup screen.
3
q Select the input terminal. w Switch to the setting screen.
MODE:
DSP: The analog input signal is converted into a digital signal and undergoes DSP processing.
System Setup settings (speaker configuration, channel delay, etc.) are reflected in the same way as for other input signals.
ANALOG: The analog input signal is played without DSP processing.
SW and center channel: Down-mixing is conducted by the analog circuit. Surround and surround back channels: Not output
if “No” is selected at the speaker configuration. Channel delay: Not reflected.
S.Back:
Set when MODE is set to DSP. Select according to the specifications of the player being used. Also refer to the player’s operating
instructions.
NOT USE: Select when neither SBL or SBR is connected.
SB (SBL): Select when only one surround back channel (SBL) is connected.
SBL/SBR: Select when two surround back channels (SBL and SBR) are connected.
SW Level:
Select according to the specifications of the player being used. Also refer to the player’s operating instructions.
+15dB (default) recommended. (0, +5, 10 and +15 can be selected.)
INPUT Vol.:
Set when MODE is set to DSP.
If the OVER LOAD indicator is displayed on the fluorescent tube, adjust the input level to between 0 and -20 dB.
5
Enter the setting.
The System Setup Menu reappears.
4
Select the item to be set (push the jog stick to the
up and down) then select the parameter (push the
jog stick to the left and right).
Loading ...
Loading ...
Loading ...