Loading ...
Loading ...
Loading ...
Installation
*INSTALLATION*
57
Refitting the door
Take the appliance door and guide
the upper door bearing bush into the
hinge pin at the top of the appliance.
Swing the door in, and fit hinge pin
into hinge plate.
Important! If necessary turn the hinge
pin so the stub points to the inside of
the door and the gap to the outside.
The hinge pin will then engage in posi-
tion.
Carefully tip the appliance back with
the help of a second person, and
screw the safety screwback in to
the support. Tighten it with the span-
ner supplied.
Realign the door with the appliance
housing again if necessary using the
long slots in the lower hinge plate.
Then tighten the screws.
Refitting the handle
The door seal will be damaged if
the handle is fitted incorrectly.
Please make sure you follow the in-
structions below carefully when you
refit the handle.
Loosely attach the handle to the op-
posite side of the door with the two
front screws .
Mounting plate must be positioned
on the side of the door so that when the
door is closed it is flush with the side of
the appliance.
If this is not the case:
Turn the two pre-mounted set screws
with a hex key until the mounting
plate is positioned at the correct
angle.
Firmly tighten all 4 screws .
From the appliance side, slide the
sidebar into the guide on the
mounting plate until it audibly clicks
into place.
Loading ...
Loading ...
Loading ...