Furrion FCR10DCDTA-BR-SV 10 cu. ft. Arctic 12 Volt Built-In Refrigerator - 2019

User Manual - Page 13

For FCR10DCDTA-BR-SV.

PDF File Manual, 53 pages, Read Online | Download pdf file

FCR10DCDTA-BR-SV photo
Loading ...
Loading ...
Loading ...
13
English
Cleaning and Maintenance
Cleaning Refrigerator Interior
It is recommended to clean the interior as needed due to
spills and other cleaning needs, or each time a new charcoal
filter is replaced.
Cleaning your Door Panels
Keep the refrigerator outside clean. Wipe with a clean cloth
lightly dampened with kitchen appliance wax or mild liquid
dish detergent. Dry and polish with a clean, soft cloth.
Do not wipe the refrigerator with a soiled dish cloth or wet
towel. These may leave a residue that can erode the paint.
Do not use scouring pads, powdered cleaners, bleach or
cleaners containing bleach because these products can
scratch and weaken the paint finish.
Battery Maintenance
Your refrigerator has an automatic shut-off switch, should the
voltage drop below 9.6V at the terminal connection. This is to
help prevent permanent damage to your batteries.
NOTE: Once voltage is re-established the refrigerator will
begin working automatically per the setting of the dial.
When possible maintain the float voltage listed on your
battery. Solar is a good way to maintain battery voltage if
a local power source is not available. Contact Furrion for
further questions or options on Solar.
Replacing the Interior LED
WARNING
Electric Shock Hazard
Remove power to the refrigerator by turning off the
converter, disconnecting the battery main, or pulling the
fuse. Failure to do so may result in electrical shock or
personal injury.
Before removing the LED, turn the refrigerator temperature
control to the OFF position. Replace the old LED with a new
LED of the same wattage and size. Contact Furrion or Furrion
authorized dealer to purchase a genuine Furrion replacement
LED (C-FCR10DCDTA-S01).
1. Unscrew the three screws (Fig. 23)
Fig. 23
2. Press the cover backwards toward the rear of the unit and
open it. (Fig. 24)
Fig. 24
3. Remove the clip and two screws to replace the old LED
with a new LED. Fix the clip and tighten the screws. Then
reinstall the cover. (Fig. 25)
Fig. 25
Replacing the Charcoal Filter
It is recommended to replace the charcoal filter every
three months of active use. Contact Furrion or Furrion
authorized dealer to purchase the replacement charcoal filter
(C-FCR10DCDTA-B01).
Replace the charcoal filter by pulling it out from the
refrigerator as shown in Fig. 26 and replace with a new one.
Loading ...
Loading ...
Loading ...