Craftmade TG52BNK3-UCI Targas 52" LED Brushed Polished Nickel Indoor Ceiling Fan

User Manual - Page 11

For TG52BNK3-UCI.

PDF File Manual, 24 pages, Read Online | Download pdf file

TG52BNK3-UCI photo
Loading ...
Loading ...
Loading ...
reverse switch
page 10
It is recommended that you test fan before finalizing installation.
Restore power from circuit box and light switch (if applicable). Test
wall control (optional installation) by locating ON/OFF slider switch
on wall control, then set to the ON position. Test light and dimmer
function and then test fan speeds. Next, locate handheld remote
control. Test the light ON/OFF function by pressing the L1 button;
test the dimmer function by pressing the L1 button and holding it
down for 1 second. Test fan speeds with the different fan speed
buttons. If the wall or handheld remote control operates all of the
functions of the fan, battery has been installed correctly. If the wall
or handheld remote control does not operate all of the fan/light
functions, refer to "Troubleshooting" section to solve any issues
before contacting Customer Service.
Turn fan completely off before moving the reverse switch (located
under the yoke cover on the motor housing). Set reverse switch to
recirculate air depending on the season:
- LEFT position in summer (diagram 1)
- RIGHT position in winter (diagram 2)
A ceiling fan will allow you to raise your thermostat setting in
summer and lower your thermostat setting in winter without feeling
a difference in your comfort.
Important: Reverse switch must be set either completely to the LEFT
or completely to the RIGHT for fan to function. If the reverse switch is
set in the middle position (diagram 3), fan will not operate.
NOTE: If the wall control or handheld remote control interferes with
other appliances, follow instructions in Section 13.
12. Testing Your Fan.
11. Remote Control Operation.
ON/OFF slider switch - turns wall control ON or OFF
(switch not functional on handheld remote)
HIGH button - turns fan to HIGH speed
MED button - turns fan to MEDIUM speed
LOW button - turns fan to LOW speed
OFF button - turns fan OFF
L1 button - turns light kit ON/OFF when pressed once;
dims light kit when pressed and held down
wall control
handheld
remote control
11
-
diagram 1
diagram 2 diagram 3
11
-
11
-
13. Re-syncing Fan and Remote.
If it becomes necessary to re-sync your fan and wall control/handheld remote control:
If using the wall control, turn power off and then on. Set slider switch on wall control to the ON position.
Within 60 seconds of turning on the wall control, press and hold the fan OFF button on the wall control for 5
seconds or until light blinks twice or blades begin to turn.
If using the handheld remote control, turn power off for at least 5 seconds and then turn power back on.
Within 60 seconds of restoring the power, press and hold the OFF button on the front of the handheld remote
control for 5 seconds or until light blinks twice or blades begin to turn.
Test the light and fan functions to confirm the fan and wall control or handheld remote control are synced. See
Section 11 for “Remote Control Operation.”.
Loading ...
Loading ...
Loading ...