Loading ...
Loading ...
Loading ...
PART 1: HOOD INSTALLATION GUIDE
Wall Hung Canopy Hood
Models included: X5L09S5, X5S09S5, X5V09S5, X5R09S5, X5M10S5 and X5N12S5
10
STEP 1:
Measure the height (H1) of the hood from the base to the top of the Mounting
Hooks. Ensure the hood is mounted as close to the centre of the cooking surface
as possible.
NOTE:
The height (H2) of the underside of the hood body must be a minimum of
600mm above an electric cooktop, for a gas cooktop a minimum of 600mm
above the highest part of the highest burner and a maximum height of
1200mm. If the instructions of the hob specify a greater distance than the
minimum detailed, this shall be the minimum height for installation.
A comfortable installation height would be 700 – 750mm gap between the
base of the rangehood and the highest part on your cooktop.
For installation over a BBQ, the hood must be installed a minimum of 1200mm
above the cooking surface. Building codes that stipulate a minimum dimension
may vary from state to state, please check with your local council prior to
installation.
STEP 2:
Using a spirit level mark a vertical centre line on the wall where the Mounting
Bracket needs to be positioned. It is recommended to centre the hood unit to the
cooktop below.
STEP 3:
Mark a horizontal line on the wall for the Mounting Bracket position. Centre and
mark the four (4) xing points in the vertical section on the left and right side of
the bracket. Drill and plug holes with suitable sized wall plugs (not provided).
STEP 4:
Fix the Mounting Bracket with four (4) suitable screws into the wall at the
positions marked in step 3 to allow the body of the hood to be hung on the wall.
STEP 5:
Hang the hood on the wall ensuring the Mounting Hooks are securely positioned
into the Mounting Bracket.
WARNING
DIMENSIONS ARE ACCURATE AT THE TIME OF PRINTING, HAUS GROUP RESERVES THE RIGHT TO
CHANGE SPECIFICATIONS WITHOUT NOTICE. FOR BUILDING PURPOSES THE UNIT SHOULD BE
PROVIDED TO THE CABINET MAKER / BUILDER / KITCHEN DESIGNER FOR EXACT MEASUREMENTS.
Wall Mounting Bracket
1
2
3
5
4
H1
H2
Hood Fixing Holes (5x) - Step 6
Wall Fixing Holes (4x) - Step 4
Loading ...
Loading ...
Loading ...