Loading ...
Loading ...
Loading ...
OPERATION
SPARK
PLI
SAFETY
IGNITION
CHOKE
CON-
THROTTLE
/ ENGINE
CONTROL
RECOIL
(AUXILIARY)
STARTER
HANDLE
POWER
CORD
PLUG
PRIMER
NOTE: ITEMS ABOVE
ARE SHOWN IN
THEIR TYPICAL
LOCATION ON THE
ENGINE. ACTUAL
LOCATION MAY VARY
WITH THE ENGINE
ON YOUR UNIT.
AUGERS
ENGINE OIL CAP AUGER DISCHARGE CHUTE CONTROL LEVER
*WITH DIPSTICK CONTROL
LEVER\ DRIVE SPEED
GASOLINEFILLERcAP_NTROL LEVER
CHUTE
DEFLECTOR
DRIVE
CONTROL
LEVER
ELECTRIC
START
BUTTON
OIL DRAIN
PLUG
FUEL SHUT-OFF VALVE
DISCHARGE
CHUTE
KNOB
MUFFLER
TOOLBOX
SKID PLATE
FIG. 8
MEETS A.N.S.I. SAFETY REQUIREMENTS
Our snow throwers conform to the standards of the American National Standards Institute.
Toolbox - used to store spare shear bolts, Iocknuts and
wrench.
Safety ignition key - must be inserted for the engine to
start and run. Remove when snow thrower is not in use.
Electric start button - used for starting the engine.
Recoil (auxiliary) starter handle - used for starting the
engine.
Primer - pumps additional fuel from the carburetor to the
cylinder for use when starting a cold engine.
Throttle/engine control - used to select either FAST or
SLOW engine speed and to STOP the engine.
Choke control - used for starting a cold engine.
Drive speed control lever - used to select forward or
reverse motion and speed of snow thrower.
Traction drive control lever - used to engage power-pro-
pelled forward or reverse motion of snow thrower.
Auger control lever -used to engage auger motion (throw
snow).
Discharge chute control lever - used to change the di-
rection the snow is thrown.
Skid plate - used to adjust height of scraper bar from the
ground.
Loading ...
Loading ...
Loading ...