• READ THESE INSTRUCTIONS THOROUGHLY BEFORE YOU BEGIN.
• Follow all local plumbing and building codes.
• Before installation, please inspect the sink for damage. Do not install a damaged sink.
• For drop-in sinks, proceed to section I. For undermount sinks, proceed to section II.
• The sink provided is considered a universal mount sink; it can either be installed as a traditional top mount
or an undermount with 1/8” countertop reveal. The template, provided with the sink, illustrates the
appropriate countertop cutout for an undermount installation - Do not use this template for top mount
installations.
•
• It is recommended that you discuss this with your customer and agree to what the finished effect will be.
Elkay is not responsible for improper sink or countertop installations.
Elkay is not responsible for sink and countertop if damaged during installation.
I. DROP-IN INSTALLATION
Quartz Universal Mount Sink
Installation Instructions
TO BE REMOVED FOR USE BY THE OCCUPANT!
ILLUSTRATION B
ILLUSTRATION C ILLUSTRATION D
SILICONE CAULK
(NOT INCLUDED)
CLOSED
CLAMP
ILLUSTRATION E
5. Determine if your sink was shipped with the ORANGE DOWEL CLIP or the BLACK / GRAY SLOTTED SCREW CLIP. If
ORANGE DOWEL CLIP, go to step 7. If BLACK / GRAY SLOTTED SCREW CLIP, proceed to step 6.
6. As shown in illustration C and D, align clips with the corresponding slots in the sinks per illustration C. It may be necessary to
use a mallet and wood block to push it into place, as shown in illustration E. Make sure metal portion of the clip (clamp) is in the
open position so that sink can be dropped into cutout. Proceed to step 8.
Note: MUST SUPPORT FAUCET DECK ON BOTH SIDES WHILE
PUNCHING FAUCET HOLES.
3. Faucet Holes: Faucet holes can be identified by the faucet hole
emboss on the underside of the faucet deck and the corresponding
circular labels located on the faucet deck top surface. Before
punching the holes please verify that the circular labels are properly
centered over the faucet emboss. The faucet hole should be
carefully penetrated FROM ABOVE THE SINK using chisel or screw
driver and tapping lightly on the circular labels. (See illustration B).
If necessary the hole can been enlarged using a metal hole saw, a
jigsaw with a metal cutting blade
or a metal file.
4. Attach faucet, drain fittings and accessories according to the
manufacturer’s instructions.
ILLUSTRATION A
TRACE COMPLETELY
AROUND EDGE OF SINK
DRAW SECOND
LINE INSIDE SINK
OUTLINE (CUT LINE)
5/16"
Note: The clips provided are designed for a maximum countertop
thickness of 1-3/4”.
1. To determine the proper size opening for your sink place the sink
upside down on top of the countertop. Mark or trace line around the
edge of the rim. Then cut an opening 5/16” inside the line. (See
illustration A).
2. Set new sink in opening to see that it fits properly.
Loading ...
Loading ...
