Loading ...
Loading ...
Loading ...
Service and Adjustment (cont'd)
7. Lift out the tab as shown to undip the terminal cover from
the thermostat. The terminal cover can now be removed
from the thermostat.
Ll_ out tsb _ m_d_
TERMINAL COVER
CLIPPED TO THER.
Mob-rAT AT THIS
POINT
m
LOWER THERMOSTAT
PLASTIC TABS ON
'BOTH SIDES OF
TERMINAL COVER
HOLD IT IN
PLACE.
THERHOSTAT
/SRACKST
9_"TANK
_LEHENT
jAC_S_ _
8. Disconnect the two wires on the element and unscrew the
old element from the tank.
12. Close the water heater drain valve by turning the handle to
the right (clockwise). The drain valve is on the lower front
of the waterheater.
13. Open the cold water supply valveto the water heater.
NOTE: The cold water supply valve must be left open
when the water heater is in use.
14. To insure complete filling of the tank, allow air to exit by
opening the nearest hot water faucet. Allow water to run
until aconstant flow is obtained. This will let air out of the
water heater and the piping.
• A CAUTION .
Never use this water heater unless it is complete.l.y full of
water. To prevent damage to the tank and heating ele-
ment, the tank must be filled with water. Water must
flow from the hot water faucet before turning "ON"
powen
15. Check element for water leaks. If leakage occurs, tighten
element or repeatsteps 2 and 3, removeelement and reposi-
tion gasket.Then repeatsteps 11 through 15.
16. Reconnect the two wires to the element and then check to
make sure the thermostat remains firmly against the surface
of the tank.
9. Clean the area around the element opening. Remove any
sediment from or around the element opening and inside
the tank.
10. If you arecleaning the element you have removed, do so by
scraping or soaking in vinegar ora de-liming solution.
AWARNING
Replacement elements must (!) be the same voltageand
(2) no greater wattage than hsted on the model rating
p ate affixedto the water heater.
11. A new gasket should be used in all cases to prevent a possi-
ble water leak. (See Element Gasket in the Parts Order
List" Chart). Place the new element gasket on the thread
side of the cleaned or new element and screw into tank,
securing tightly using an element wrench.
17. Replace the terminal cover on thermostat.
©
19
Loading ...
Loading ...
Loading ...