Loading ...
Loading ...
Loading ...
1. The hose must be protected from contact with
hot or sharp surfaces both during use and while
in storage. The hose assembly should be visually
inspected prior to each use of the appliance. If
excessive abrasion or wear is evident, or the hose
is cut, it must be replaced prior to operating the
appliance. The replacement hose assembly may be
obtained from the manufacturer.
2. DO NOT use any pressure regulator or hose
assembly other than those supplied with the
appliance. Replacement pressure regulator
and hose assembly must be those specified.
Replacement parts maybe obtained from the
manufacturer or your local sales
representative.
3. Installation and use of this appliance must conform
with local codes and AS/NZS 5601.
LPG GUIDELINES
If the product has been converted to LPG, then you
must ensure the following conditions:
1. This appliance is designed to operate with a
standard 9kg propane cylinder with Approved
Cylinder Connection.
2. The valve outlet must be maintained in good
condition. When the cylinder is not in use, be sure
to cover it with a dust cap. A leak test should be
performed with soapy water whenever connecting a
new cylinder. NEVER use a match to test for leaks.
3. The propane cylinder must be turned off whenever
the appliance is not in use. When the appliance is
to be stored indoors, the propane cylinder and the
appliance must be disconnected and the cylinder
stored in accordance with the Standard for Storage
and Handling of Liquefied Gases.
IMPORTANT
Storage of an appliance indoors with the cylinder
attached is only permitted if the size of the cylinder
complies with AS/NZS 1596; otherwise cylinders
must be stored outdoors in a well ventilated area.
The guards are fitted to this appliance to reduce the
risk of fire or injury from burns and no part of it should
be removed.
This appliance must be protected from exposure to
rain and wind.
SPECIFICATIONS
Gas type LPG NATURAL GAS
Manufactured by Gasmate
AGA Approval No.
Gas Consumption 35 MJ/h 35 MJ/h
Gas Type Propane Gas (LPG) Only Natural Gas
Gas Pressure 2.75 KPA 1 KPA (RH205), 0.8KPA (RH200)
Injector Size 1.6mm 2.80mm (RH205), 2.85mm (RH200)
Weight RH200 - 15Kg RH205 - 14Kg
Voltageq 200-240V AC 50HZ
Current >1 Amp
Note: If the appliance cannot be adjusted to perform correctly it should not be used until serviced or repaired.
Heater specifications can be found on the data label.
PRODUCT OVERVIEW
4
Loading ...
Loading ...
Loading ...