Loading ...
Loading ...
Loading ...
Avoid Service ChecMist oo oood
PROBLEM POSSIBLECAUSE/SOLUTION
SELF-CLEANINGOVEN (SOME MODELS)
Self-clean cycle does not work. Follow steps specified in this manual for appropriate settings of controls.
Door was not closed properly. Close door and start appropriate clean cycle again.
Soil not completely removed after Failureto clean the bottom or front top of oven or door area, these surfaces get hot enough
self-cleaning cycle, to burn on residue. Self cleaning of area underneath a closed door is not efficient. Clean
these areasbefore the self-cleaning cycle isstarted. Burned on residue may be cleaned with
a stiff nylon brush and water or nylon scrubber. Be careful not to damage the oven seal.
Clean cycle too short. Put oven through an additional cycle.
Check for temporary lossof power. Resetthe controls and put the oven through another
self-clean cycle.
These are normal; they are caused by the oven door lock mechanism.There's some strange noise at the
beginning of the self-clean cycle.
Avoid Transportation Damage to your Range
If you have to move your range into/out of your residence or when moving to a new home, it is suggested that you take tile
following precautions:
1. Screw in the levelling legs under tile range.
2. Remove the racksand other utensils from the oven, and from the lower drawer.
3. Useadhesive tape to firmly secure the door and the drawer to the side panels. Also attach the electric power cord in the same
manner.
4. Usea two-wheeled dolly with strap and fasten tile range to it. Cover the appliance with a heavy blanket to prevent scratches
and dents.
5. Avoid pulling or pushing tile control panel when moving the appliance.
33
Loading ...